Formufit F0013WE-RD-4 Installation guide

Type
Installation guide
3-Way PVC Fitting
FORMUFIT 3-Way PVC Fittings can accept up to three (3) segment of PVC pipe and can be
used to create corner joints for cubes and rectangles. To connect this product to PVC pipe,
follow the instructions shown below.
Assembly
Securing
For permanent and strong connections, it is!recommended to use!PVC cement/solvent to
attach the PVC pipe and 3-Way PVC Corner fitting.
You can also temporarily connect this fitting by driving a self-tapping screw where the pipe
and fitting meet, or apply electrical tape over the end of the pipe before inserting into the
fitting for a temporary, yet strong connection.
All rights reserved. TM, ® & Copyright © 2009-2018 FORMUFIT LC
https://formufit.com
PRODUCT INSTRUCTIONS
Slip a segment of!PVC pipe inside one
of the sockets on the!3-Way fitting.
Push or tap into place until the pipe
hits the stop inside of the socket.
Repeat for each additional socket.
1
2
  • Page 1 1

Formufit F0013WE-RD-4 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI