Formufit F11445E-YE-4 Operating instructions

Brand: Formufit

Model: F11445E-YE-4

Type: Operating instructions

45 Degree PVC Fitting

FORMUFIT 45 Degree PVC Fittings can accept up to two (2) segment of PVC pipe and can be

used to create 45 degree angles in PVC pipe projects. To connect this product to PVC pipe,

follow the instructions shown below.

Assembly

Securing

For permanent and strong connections, it is!recommended to use!PVC cement/solvent to

attach the PVC pipe and 45 Degree PVC Elbow ﬁtting.

You can also temporarily connect this ﬁtting by driving a self-tapping screw where the pipe

and ﬁtting meet, or apply electrical tape over the end of the pipe before inserting into the

ﬁtting for a temporary, yet strong connection.

All rights reserved. TM, ® & Copyright © 2009-2018 FORMUFIT LC

https://formuﬁt.com

PRODUCT INSTRUCTIONS

Slip a segment of!PVC pipe inside one

of the sockets on the!45 Degree ﬁtting.

Push or tap into place until the pipe

hits the stop inside of the socket.

Repeat for each additional socket.

1

2

1

Formufit F11445E-YE-4 Operating instructions

Brand: Formufit

Model: F11445E-YE-4

Type: Operating instructions

Download PDF

Related papers

Other documents