Enabling Devices 5004 User manual

5004
Brand
Enabling Devices
Model
5004
Type
User manual

Enabling Devices 5004 is a self-contained communication device that allows users to record and playback messages. Ideal for individuals with limited verbal communication abilities, it features large, recessed switch plates for easy activation. With four styles and seven message capacities, users can choose the model that best suits their needs. Record messages by pressing and holding the record button, then speak into the microphone. Playback messages by pressing the corresponding switch plate. The device retains recorded information indefinitely, even if the battery is disconnected.

Enabling Devices 5004 is a self-contained communication device that allows users to record and playback messages. Ideal for individuals with limited verbal communication abilities, it features large, recessed switch plates for easy activation. With four styles and seven message capacities, users can choose the model that best suits their needs. Record messages by pressing and holding the record button, then speak into the microphone. Playback messages by pressing the corresponding switch plate. The device retains recorded information indefinitely, even if the battery is disconnected.

For Technical Support:
For Technical Support:For Technical Support:
For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-832-8697
customer_support@enablingdevices.com
Hip Talk #5004
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. 914.747.3070 / Fax 914.747.3480
Toll Free 800.832.8697
www.enablingdevices.com
www.enablingdevices.comwww.enablingdevices.com
www.enablingdevices.com
Hip Talk
Hip TalkHip Talk
Hip Talk is a self-contained communication device that allows the
user to record and playback messages. Hip Talk comes in a total of
four styles and seven different message capacities. The one, two or
four message models come in a soft nylon zippered pack with a waist
strap and feature large recessed switch plates(s) on top for easy
access.
OPERATION:
OPERATION:OPERATION:
OPERATION:
1. Using a screwdriver, remove the screw on the battery
compartment and remove the battery compartment cover.
Observing polarity, install 4 AA batteries (Not included). Screw the
battery compartment cover back into place.
2. The microphone is located on the side of the unit and the RECORD
button is located on the bottom of the unit (see diagram on back).
To record a message, depress and hold the RECORD button, then
depress one of the switch plates and speak into the microphone.
Release both buttons once recording is over. Playback your
message by pressing and releasing the same switch plate used to
record. Each of the remaining switch plates can be programmed in
the same manner. The unit will retain recorded information
indefinitely, even if the battery is disconnected. Previously stored
information will be erased only when a new recording is
performed.
IMPORTANT NOTES:
IMPORTANT NOTES:IMPORTANT NOTES:
IMPORTANT NOTES:
If you exceed the maximum length for any single message, the unit will
use the memory of succeeding buttons. Bear in mind, however, that if
message length exceeds available memory amount, it will wrap
around over itself at its beginning.
If the unit fails to operate, or operates incorrectly, the following steps
should be performed:
Disconnect the power by removing one of the batteries for 20
seconds, to reset the unit. If the unit still does not work correctly
after the battery is reconnected, replace all the batteries.
Make sure there are no obstacles between the switch buttons and
the housing of the unit.
If you have any problems or questions about this unit or any of our
products, please call our Technical Assistance Department
Rev
Rev Rev
Rev 5
55
5/
//
/25
2525
25/1
/1/1
/17
77
7
  • Page 1 1
  • Page 2 2

Enabling Devices 5004 User manual

5004
Brand
Enabling Devices
Model
5004
Type
User manual

Enabling Devices 5004 is a self-contained communication device that allows users to record and playback messages. Ideal for individuals with limited verbal communication abilities, it features large, recessed switch plates for easy activation. With four styles and seven message capacities, users can choose the model that best suits their needs. Record messages by pressing and holding the record button, then speak into the microphone. Playback messages by pressing the corresponding switch plate. The device retains recorded information indefinitely, even if the battery is disconnected.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents