2. Lumination
  3. Allusion Glow Lens

Lumination Allusion Glow Lens Installation guide

  • Hello! I've reviewed the provided installation guide for the LALR and LALS Starter Kits glow diffusers. This document contains the instructions for proper installation, safety warnings, and troubleshooting tips. I'm ready to assist you with any questions you may have about installing the glow diffuser.
  • What should I do before starting the installation?
    What are the electrical safety precautions?
    What type of wire should be used for connections?
    What should I do if components are not fitting together?
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 2
(Rev 05/23/23)
IND555-Lumination-Allusion-Glow-Difuser-Installation-Guide
WARNING/AVERTISSEMENT
Installation Guide
Allusion
Glow Diuser Installation Supplement
BEFORE YOU BEGIN
Read these instructions completely and carefully.
RISK OF ELECTRIC SHOCK
• Turn power o before inspection, installation or removal.
• Properly ground electrical enclosure.
RISK OF FIRE
• Follow all NEC and local codes.
• Use only UL approved wire for input/output connections.
Minimum size 18 AWG.
• Type IC, inherently protected.
RISK OF INJURY
• Diuser may fall down if not installed properly.
RISQUES DE DÉCHARGES ÉLECTRIQUES
• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le
luminaire.
• Assurez-vous de correctement mettre à la terre le boîtier
d’alimentation électrique.
RISQUES D’INCENDIE
• Respectez tous les codes NEC et codes locaux.
• N’utilisez que des ls approuvés par UL pour les entrées/sorties de
connexion. Taille minimum 18 AWG.
• Type IC, protection inhérente.
RISQUES DE BLESSURE
• Le volet peut tomber s’il n’est pas installé correctement.
Note:
This document is a supplement for the glow diuser installation. Complete xture install instructions have been provided with
the xture.
Provided in the Package
A glow diuser will be included in the packaging with each xture.
• LALR Starter Fixtures: Glow diuser endcaps (Qty. 2)
• LALS Starter Kits: Glow diuser endcaps (Qty. 2)
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 2 of 2
(Rev 05/23/23)
IND555-Lumination-Allusion-Glow-Difuser-Installation-Guide
Lumination® (Glow Diuser Installation Supplement) Installation Guide
Installation
Push diuser so both hooks engage the housing. Inspect
along length of xture to ensure proper connection
2
Squeeze snap hooks together.
Complete the enclosure by installing the endcaps. Slide
diuser under endcap to ensure no LEDs are visible.
1
3
Troubleshooting
Symptom Solution
Components are not tting together. Check the table below to ensure correct parts are being used.
LALS LALR Diuser
Glow Distribution
Endcap
Medium Distribution
Endcap
Glow Distribution
Endcap
Medium Distribution
Endcap
Glow Distribution
(GL)
Medium Distribution
(MM)
Height = 5.0 in Height = 4.5 in Height = 4.5 in Height = 3.8 in Height = 0.8 in Height = 0.3 in
/