Philips PDUVCC Installation guide

Type
Installation guide

Philips PDUVCC is a UV-C controller that enables you to install UV-C lighting in an approved enclosure. It features an emergency stop system, system key switch, and occupancy and door sensors for added safety. With its easy installation process and compliance with electrical and construction codes, it's a reliable choice for UV-C lighting control.

Philips PDUVCC is a UV-C controller that enables you to install UV-C lighting in an approved enclosure. It features an emergency stop system, system key switch, and occupancy and door sensors for added safety. With its easy installation process and compliance with electrical and construction codes, it's a reliable choice for UV-C lighting control.

SYSTEM KEY SWITCH
STA RT
Installation Instructions
Instrukcje Instalacji
Installatie-instructies
安装指示
UV-C CYCLE RUNNING
SYSTEM READY
SYSTEM ARMED
OCCUPANCY
DETECTED IN AREA
DOORS OPEN
IN AREA
AREA EMERGENCY
STOP PRESSED
CABINET EMERGENCY
STOP PRESSED
SYSTEM ERROR
PDUVCC
UV-C Controller
EMERGENCY STOP SYSTEM KEY SWITCH
ARMED
OFF STA RT
2-4 mm
(0.08-0.16 in)
40° C (104° F)
0° C (32° F)
90%
PDUVCC
DACM Language Kit 2
1
32
Devices must be installed in an
approved enclosure by a qualied
electrician in accordance with all
national and local electrical and
construction codes and regulations.
Urządzenia muszą być zainstalowane przez
wykwalikowanego elektryka, zgodnie ze
wszystkimi krajowymi i lokalnymi przepisami, a
także regulacjami elektrycznymi i budowlanymi.
De apparaten moeten worden aangebracht
door een gekwaliceerde elektricien en in
overeenstemming met alle nationale en
plaatselijke elektriciteits- en bouwvoorschriften.
デバイスは、国および地域の電気および建設に関す
るすべての法規と規制に従って、資格のある電気技
師が設置する必要があります。
AZZ 527 0922 R04
© 2022 Signify Holding. All rights reserved. Specications are subject to
change without notice. No representation or warranty as to the accuracy or
completeness of the information included herein is given and any liability
for any action in reliance thereon is disclaimed. Philips and the Philips
Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other
trademarks are owned by Signify Holding or their respective owners.
www.dynalite.com
This is a class A product. In a domestic environment this product may cause radio interference, in which case the user may be required to take adequate measures.
Installation of a home and building automation and control system shall comply with IEC 60364 (all parts). The temperature limits and current-carrying capacities
for the communication wires specied in IEC 60364-5-52 shall not be exceeded.
SHLD
GND
D+
D–
+V
SHLD
GND
D+
+V
D-
Kit 2
SHLD
GND
D+
D–
+V
SHLD
GND
D+
+V
D-
1
3
2
1.0 Nm
8.8 Lb-in
4
6
9
5
SHLD
GND
D+
D–
+V
0N
0FF
1 2 3 4 5 6
1
24
8
16
32
6. Polski
7. Nederlands
8. 日本語
8
10
SHLD
GND
D+
D–
+V
0N
0FF
7
11
Please dispose of waste electronics according to
local regulations.
Odpady elektroniczne należy unieszkodliwiać
zgodnie z lokalnymi przepisami.
Gelieve afvalelektronica te verwijderen volgens
de lokale voorschriften.
廃電子機器は現地の規制に従って処分してください。
  • Page 1 1
  • Page 2 2

Philips PDUVCC Installation guide

Type
Installation guide

Philips PDUVCC is a UV-C controller that enables you to install UV-C lighting in an approved enclosure. It features an emergency stop system, system key switch, and occupancy and door sensors for added safety. With its easy installation process and compliance with electrical and construction codes, it's a reliable choice for UV-C lighting control.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI