Signature Hardware 142972 Installation guide

1Kitchen Drain Installation Instructions

KITCHEN DRAIN

INSTALLATION INSTRUCTIONS

Before installing, read entire Strainer Basket Installation Instructions. Observe all local building and safety codes.

Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer

Service at 1.866.855.2284. If you need assistance or have questions while installing your strainer basket, contact

Customer Service.

We recommend consulting a professional if you are unfamiliar with installing kitchen xtures. Signature Hardware

accepts no liability for any damage to the strainer, sink, or for personal injury during installation.

TOOLS AND MATERIALS:

INSTALLATION

1. Apply a bead of silicone sealant to the base of the strainer ange.

2. Place the ange in the drain opening in the kitchen sink.

3. If your drain has a disposer ange, use the directions supplied with the garbage disposer to attach the disposer and

complete your installation. For drains with strainer baskets, slide the rubber gasket and friction washer up the

strainer ange to the bottom of the sink.

4. Thread the lock nut onto the drain assembly. Hand-tighten and make sure that the drain is properly aligned. When

ready, nish tightening with a basin wrench to secure the drain

5. Secure the P-trap to the strainer ange with the provided compression nut and ferrule.

Silicone Sealant (for copper sinks, use a neutral cure silicone sealant)

Basin Wrench