MULTIPLEX MPX-178 BIC Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the MULTIPLEX MPX-178 BIC Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Service Bulletin
Subject: BIC Manual Fill Blender Passwords for Motor &
Blender Shaft Replacements
SCOPE: ALL BIC MANUAL FILL UNITS WITH 4.0.8 & UP
1 of 2

MULTIPLEX
645 PARK EAST BLVD SUITE 5, NEW ALBANY, IN 47150
844-724-CARE
WWW.MULTIPLEXBEVERAGE.COM
Refreshing the Experience
Every time a blender shaft or motor is replaced on a BIC Manual Fill, a password must be entered to record the replacement
date.




ACTION

1. Navigate to the Managers Menu on the easyTouch
screen.
2. Enter “A” as the password then press GREEN check.
3. Press the DOWN ARROW.
 
 Enter password then press green check.
PASSWORD PART REPLACED
 
 
 On confirmation screen select green check.
7. 
8. Confirm blender cycle counts and maintenance date
reset.

1. Navigate to the Managers Menu on the easyTouch
screen.
2. Enter “A “as the password then press GREEN check.
3. Press DOWN arrow.
2 of 2

Subject: BIC Manual Fill Blender Passwords for Motor & Blender Shaft Replacements
 Press the SERVICE wrench at top.
 Enter “A” as the password then press GREEN check.
 Press the DOWN arrow.
7. 
8. Select MIXER MAINTENANCE PERFORMED.
 Enter password then press green check.
PASSWORD PART REPLACED
 
 
OEARMOTR 
 
NOTE: Password begins with letter “O” NOT zero.
On confirmation screen select green check.
11. 
12. If blender shaft changed confirm blender cycle counts
and maintenance date reset.
FURTHER ACTIONS

any questions or concerns.
/