Therma-Stor 4037768 Installation guide

Brand: Therma-Stor

Model: 4037768

Type: Installation guide

Step 1. Insert Grommets

In-Wall Dehumidiﬁer

Rear Panel Kit

Part No. 4037768

Parts Included:

1. Rear Panel

2. Screw A (x5) - Pan Head, course pointed screw for wood

3. Screw B (x5) - Truss Head, self-drilling screw for metal studs

4. Plastic Grommet / Drain Hose Bushing

Tools Required:

• Drill/Screwdriver

TS-1056 7/18 Rev B

4201 Lien Rd Madison, WI 53704 • TOLL-FREE 1-800-533-7533 • www.thermastor.com • [email protected]

2

3

4

Insert plastic grommet included with

the in-wall dehumidier to the back of

the unit after punching out the knock

out hole for the drain hose.

Insert plastic grommet included with

this kit to the back of the rear panel.

(x5)

(x5)

CONTINUED

4038985 4037854

DRAIN HOSE

BUSHING

REMOVE DRAIN HOSE

KNOCK OUT

1.6"

32.2"

16.6"

1

4201 Lien Rd Madison, WI 53704 • TOLL-FREE 1-800-533-7533 • www.thermastor.com • [email protected]

TS-1056 7/18 Rev B

Route the drain hose through the

rear panel and the dehumidier to

connect to the drain pan.

Be sure the drain hose knock out

and the electrical wiring knock out

on the rear panel line up with the

dehumidier.

Step 2. Install Drain Hose

Step 3. Install Rear Panel

Check that there is no strain on

the drain hose and power cord.

Locate the four holes on the rear

panel and fasten to the wall with

the appropriate screws based on

the stud type. Screw A can be

used for wood studs and Screw B

can be used for metal studs.

4037854

DRAIN HOSE

DRAIN HOSE

BUSHING DRAIN HOSE

SIDE VIEW

SCREW B

1
2

Therma-Stor 4037768 Installation guide

Brand: Therma-Stor

Model: 4037768

Type: Installation guide

Related papers

Other documents