INSTRUCTION MANUAL
S22002
2300W Steam Station
For An Additional One Year Guarantee
Please Register Your Appliance
At e Website Below
and enjoy the peace of mind
of a
TECHNICAL SUPPORT
If you require technical support or in the unlikely event that your purchase is faulty please
telephone our Help line for immediate assistance.
0871 221 3624
OR
www.signaturebrand.co
www.signaturebrand.co
e wires in the mains lead are coloured in accordance with the following code:
GREEN/YELLOW: EARTH (E)
BLUE: NEUTRAL (N)
BROWN: LIVE (L)
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured mark-
ings identifying the terminals in your plug, proceed as follows:
e wire which is coloured GREEN & YELLOW must be connected to the terminal in the plug which is
marked with the letter “E” by the earth symbol
or coloured GREEN/YELLOW.
e wire which is coloured BLUE must be connected to the terminal which is marked with the letter “N”
or coloured BLACK.
e wire which is coloured BROWN must be connected to the terminal which is marked with the letter “L”
or coloured RED
Always ensure that the Mains Cord is xed into the plug through the Cord Guard or Cable Clamp,
(plug wiring diagram above), and that the Cord Guard screws are tightened to clamp the Cord (outer sheath
and inner coloured wires) into position in the plug. Make sure that plug top is also tted securely.
is appliance must be protected by a 13 Amp fuse in a 13 Amp type (BS1363) plug. Should you need
to replace the fuse, use only a 13Amp ASTA approved BS1362 fuse (13A).
1
1 Base unit
2. Sole plate
3. Steam button
4. Temperature control.
5. Steam On /O switch
6. Steam ready light
7. Iron ready light
8. Safety cap
9. Iron On /O switch
Steam Iron
S22002
FTY DF-D178A
220V-240V ~50Hz 2100W
Sutton House,
Berryhill Road,
Fenton
Stoke on Trent
Staordshire,
ST4 2NL.
2
1
3
5
6
4
7
9
8
TECHNICAL DATA
PARTS IDENTIFICATION
ELECTRICAL SAFETY
2
Read all instructions before using
is Appliance is intended for household use. only.
To protect against the risk of electric shock, do not immerse the iron or base in water or other
liquids.
e iron should always be turned to “min” before plugging or unplugging from the mains outlet.
Never pull the cord to disconnect from the mains: instead, grasp plug and pull to disconnect.
Do not allow the cord to touch hot surfaces.
Allow the iron and base to cool completely before storing
Always disconnect the iron from the electrical socket when lling with water or emptying and
when not in use.
Do not operate the iron with a damaged cord or if the iron has been dropped or damaged.
ere are no user serviceable parts in the iron take it to a qualied person for examination and
repair.
Close supervision is necessary for any appliance being used near children.
Do not leave the iron unattended when connected to the mains or sited on an ironing board.
Burns can occur from torching hot metal parts or hot water \ steam, use caution when you turn a
steam iron upside down there may be hot water in the reservoir.
If the iron does not operate normally, disconnect from the power supply and contact
the nearest authorised service agent or you local qualied electrician.
Your iron is designed to rest on the heel.
Do not leave the iron unattended when switched on.
Do not place the iron on an unprotected surface even if it is on its heel rest.
is appliance is not intended for use by children or the inrm unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Keep electrical appliances out of reach from children
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a
qualied electrician or technician.
FILLING THE WATER RESEVIOUR
Before lling ensure that the unit has fully cooled and the plug is removed from the wall socket
When cool remove the reseviour safety cap and empty any water that is been le in the reseviour
en place the funnel in the opening to the reseviour.
Measure 0.5 litres (500cc) of water into the appropriate container this then poured into the rese-
viour and the safety cap is replaced and secured .
In some areas there are issues with hard
water this may cause lime scale
We recommend in areas where this
is the case distilled water is used to ll
the reseviour
USING YOUR STEAM GENERATOR
Aer lling the steam station. Ensure it is placed on a at level surface that is stable.
plug the power cord into unobstructed wall socket then switch on at the wall
set the temperature dial on the iron to the correct temperature for the fabric that is to be ironed
(as shown in the table above) then switch on the steam generator and the iron from the switches
on the base.
When the correct temperature is reached for the fabric the light on the iron may cycle on and o
this is normal and shows that the thermostat is operating normally
Ensure all switches are in the o position when you are nished with the appliance.
SAFETY INFORMATION
3
4
FABRIC CARE
It is important to get the temperature right when ironing as some fabrics are easily damaged. but
there is a number of steps that can be taken to avoid damaging the fabrics you are ironing
1. Check the label on the fabric item to nd out the correct temperature for the fabric that you
are ironing and check it against the above chart.
2. Test the temperature is right. is is done on a area where it cannot be seen and this will avoid
damaging your favourite shirt or skirt.
3. Gradually build the temperature to a level where the fabric is free from creases but has not
been damaged
4. Use a clean cloth on the top of the article that you wish to iron
5. Use the steam function however please take care as some fabrics that contain wool and other
similar materials may take on a shine aer
6..Where the fabric is made up with a mix of materials use the lowest temperature of the fabric
mix
CLEANING, STORING AND MAINTENANCE
!Caution!
Before attempting maintenance cleaning or relling of the reseviour ensure that the appliance
has been switched o and disconnected from the power supply and has been allowed to cool
completely.
We would recommend when the product is not going to be used for long periods that any water
is emptied from the reseviour and that the reseviour is rinsed to remove any lime scale build up
We do not recommend the use of harsh or abrasive chemicals to clean the enclosure use a so
damp cloth and a little detergent for stubourn marks
We would reccomend that the product is stored in its original packaging in a cool dry
enviroment
5
6
7
8
NOTESNOTES
Disposal of Unit
Disposal instructions for signature items in accordance with the WEEE directive.
Appliances bearing the symbol shown here may not be disposed of in domestic rubbish. You are required to dispose
of old electrical and electronic appliances like this separately.
Please visit www.recyclemore.co.uk, or www.recylcenow.co.uk for access to information about the recycling of electrical
items. Please visit www.weeeireland.ie for access to information about the recycling of electrical items purchased
in Ireland.
The WEEE directive, introduced in August 2006, states that all electrical items must be recycled, rather than taken
to landll. Please arrange to take this appliance to your local Civic Amenity site for recycling, once it has reached the end
of its life.
Declaration of Conformity
We PFD Ltd Declare that this product conforms to all the following
product legislation
In accordance with the following directive(s):
2004/108/EEC. e Electromagnetic compatibility Directive
2006/95EC. e LVD directive (Low Voltage Directive)
2002/95/EC. e RoHS. Directive. (Restriction of Hazardous substances Directive)
1935/2004/EC Materials & Articles in Contact with Food. (LFBG section 30, 31 & 35)
Peter Bowden
Quality Assurance Manager
Sutton House, Berryhill Road, Fenton, Stoke-On-Trent,
Staordshire, ST4 2NL.
DISPOSAL
9
10
-
1
-
2
-
3
-
4
-
5
-
6
