1
Installation Instructions for
Install the inner and outer rings to each pendant using the thumb screws.
Feed the fixture wires through the fixture loop and screw it onto the fixture.
Follow enclosed supplement installation instructions for electrical and fixture installation onto house outlet box.
Place the shade and collar nut onto the socket and secure it place by screwing the collar nut onto the socket. Repeat for
remaining shades.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
1
2
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
3
4
Loras Chandelier
1.0
F3168-3-F3169-5-F3170-6
Chandelier
F3168/3, F3169/5, F3170/6
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
This instruction shows a typical installation.
1A
LAMP
OUTER RING
PENDANT
THUMB SCREW
FIXTURE CORD
3
2
FIXTURE LOOP
INNER RING
PENDANT
OUTER RING
INNER RING
FIXTURE CORD
11
4
5
5
Page is loading ...
Page is loading ...
4
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, 60077IL
800.969.3347
www.Feiss.com
© 2017 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
/
