2. Rugged Ridge
  3. 17235.56

Rugged Ridge 17235.56 Installation guide

  • Hello! I've reviewed the installation instructions for the Rugged Ridge A-Pillar Switch Pod (Left Side - 2007 - UP JK). The document details how to install the switch pod, reuse factory clips. I'm ready to answer any questions you have about the process.
  • What tools are needed for installation?
    Are switches included with the A-Pillar Switch Pod?
    What should be done with the factory metal retainer clips?
Jeep® A-Pillar Switch Pod (Left Side - 2007 - UP JK)
Page 1 17235.56Rev (1) 10/28/10
HARDWARE NOTE: Switch Pod has been
designed to reuse factory metal retainer
clips located on the back of factory trim.
DO NOT DISCARD.
Important! Please read instructions completely before installing Switch Pod.
Step 1. Using T20 Torx head
screw driver remove
left side sun visor.
Remove side plastic
retainer clip from upper
left side windshield trim
(Pic.1)
Step 2. Remove upper trim from
windshield frame (Pic.2).
P/N: 17235.56
Step 3. Pop lower A-pillar trim
from windshield frame.
(Pic.3)
(Pic.1) (Pic.2) (Pic.3)
Step 4. Using a small flat head
screwdriver remove the
retainer clips form trim
(Pic.4)
Step 5. Install clips to new A-pillar
(Pic.5)
Step 6. Use a box knife to cut
along switch locator
guides (Pic.6) (Pic.4) (Pic.5) (Pic.6)
Step 7. Install switch into cutout
(Pic.7)
Step 8. Snap new Switch Pod
into windshield guide
holes (Pic.8).
Step 9. Reinstall upper trim
as described in steps
1 - 2 (Pic.9)
Item List:
(1) A-Pillar Switch Pod - Left Side Switches sold separately
---------------------------------
17235.01 - Amber
17235.02 - Red
17235.03 - Blue
17235.04 - Green
(Pic.7) (Pic.8) (Pic.9)
/