2. Rugged Ridge
  3. 17235.55

Rugged Ridge 17235.55, 17235.73 Installation guide

  • I have reviewed the installation instructions for the Rugged Ridge JK Center Console Switch Pod. This document details the steps required to install the switch pod in 2007-2010 Jeep JK vehicles, including reusing factory clips and preparing for aftermarket switches. I'm ready to answer any questions you have regarding the installation process or its features.
  • Does the switch pod come with switches?
    Do I need to discard the metal clips from the factory trim?
    What if I have a 6-speed transmission?
Jeep® Center Console Switch Pod (2007 -2010 JK)
Page 1 17235.55Rev (1) 12/08/2010
HARDWARE NOTE: Switch Pod has been
designed to reuse factory metal retainer
clips located on the back of factory trim.
DO NOT DISCARD.
(Switches sold separately)
Item List:
(1) Center Console Switch Pod
Important! Please read instructions completely before installing Switch Pod.
Step 1. Move shifter back from center
console (Pic.1).
Step 2. Using a flat head screwdriver
pop factory trim panel from
center console. Retainer clips
are located on the upper left
and right corners (Pic.2).
P/N: 17235.55 JK Center Console Switch Pod
Step 3. Using a small flat head screw
driver remove metal retainer clips
(Pic.3) from factory trim. Reinstall
onto new Center Console Switch
Pod (Pic.4).
.
Step 4. To install switches use a box
knife to cut along switch locator
channels. With Switches installed
position new Switch Pod into guide
holes located in center console.
Step 5. Reinstall new switch pod
panel into center console
(Pic 6).
Note: (6 Speed) transmissions may
require the rubber boot to be
pushed clear of switch location
panel. A zip-tie can be used
to hold rubber boot in new
position.
pic. 1 pic. 2
pic. 3 pic. 4
pic. 5 pic. 6
/