2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Fishbone Offroad
  7. FB25116

Fishbone Offroad FB25116 Installation guide

  • Hello! I've reviewed the installation instructions for the Fishbone Offroad Luggage Rack designed for Jeep Wrangler 07'-18'JK. The document outlines the steps for installation, which includes mounting support plates, and cross plates, as well using included hardware. I'm ready to assist with your questions about this product based on the provided instructions.
  • What tools are required for the installation?
    What does the kit contain?
    Which way the tub rail support plates should be mounted?
FB25116
Jeep® 07’- 18’JK Wrangler
Luggage Rack
REQUIRED TOOLS
6MM Allen
17MM Socket
KIT CONTAINS
Tub Rail Support Plate (Left & Right)
Center Cross Plate
M10 Bolt
M10 Nyloc Nut
M10 Flat Washer
Hard Top Knobs
QTY
1 ea
1
6
6
16
4
FB25116
Jeep® 07’- 18’JK Wrangler
Luggage Rack
1
1) REMOVE YOUR HARD OR SOFT TOP
To make the installation easier, we recommend you
remove or loosen your hard or soft top
It’s not necessary, however.
2) INSTALL THE SUPPORT PLATES
The orientation of the support plates can be
determined by the location of the smaller,
unbranded section. ……………………………………………….
As shown above, this section will always face the
rear of the vehicle, and the tub rail holes will cover
your vehicle’s (2) most rear rail holes.
Secure them with (2) of the included Hardtop Knobs
lead by a Flat Washer.
Repeat on the opposite side.
3) INSTALL THE CENTER CROSS PLATE
With the Fishbone Offroad name plate facing the
rear of the vehicle, raise the Cross Plate up and in
between the two Support Plates. ……………………………
FB25116
Jeep® 07’- 18’JK Wrangler
Luggage Rack
2
Secure each side with (3) Bolts, (6) Flat Washers,
and (3) Nyloc Nuts. ………
………………………………………..
Tighten down the bolts with a 17MM Socket and a
6MM Allen wrench. ………………………………………..………
…………………………………….
4) ENJOY YOUR NEW FISHBONE OFFROAD LUGGAGE
RACK!
/