Fishbone Offroad FB25240 Installation guide

Type
Installation guide

This manual is also suitable for

FB25232
Jeep® 07-’18Current JK Wrangler
Tub Rail Tie Downs
REQUIRED TOOLS
13MM Socket
Ratchet
KIT CONTAINS
JK Tub Rail Tie Down (Left & Right)
Hardtop Knobs
5/16” Flat Washer
M8 Hex Nut
QTY
1 ea
4
8
4
FB25232
Jeep® 07-’18Current JK Wrangler
Tub Rail Tie Downs
1
2511300
1) REMOVE TUB ACCESSORIES
Prepare the installation area by removing any
accessories from your tub rails, including our
storage racks, bins, and any hardtop Torx bolts.
Depending on your preference or setup, the Tie
Down will sit on top of any accessory, meaning the
included knobs with secure it and anything extra.
2) TIE DOWN ORIENTATION
Determine the orientation you’d like for the Tie
Downs, as they’re driver and passenger side
specific, but can be swapped by rotating them to
face inboard or outboard.
3) INSTALL
Place all your desired accessories onto the rail with
the Tie Down finally on top. With 2 of the included
knobs, 4 washers, and 2 hex nuts, secure the Tie to
the tub rail with a 13mm socket.
FB25232
Jeep® 07-’18Current JK Wrangler
Tub Rail Tie Downs
2
2511300
If you own a Hardtop, you do not need to use the
hex nuts and 4 of the washers.
Repeat on the opposite side.
4) ENJOY YOUR NEW FISHBONE OFFROAD TUB RAIL
TIE DOWNS!
  • Page 1 1
  • Page 2 2
  • Page 3 3

Fishbone Offroad FB25240 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI