Fishbone Offroad FB22136 Installation guide

Brand
Fishbone Offroad
Model
FB22136
Type
Installation guide
FB22136
Jeep® ’07-’18 JK Wrangler
D-Ring Frame Mounts
REQUIRED TOOLS
21mm Socket
22mm Wrench
KIT CONTAINS
Nut Plate
M14 Bolt
M14 Nyloc Nut
M14 Washer
28mm Washer
QTY
2
4
2
4
2
FB22136
Jeep® ’07-’18 JK Wrangler
D-Ring Frame Mounts
1
1) REMOVE YOUR REAR BUMPER
Remove your existing rear bumper according to the
manufacturer’s instructions.
2) INSERT THE MOUNTS
Place the mounts into the frame rail slots such that
the bolt holes visually line up.
3) INSTALL HARDWARE
Starting with the inner most bolt hole, insert one of
the included 21mm bolts. On the inside of the
frame, under the vehicle, secure the bolt with one
of the included washers and nyloc nuts.
Insert another bolt into the remaining hole. In the
slot shown below, insert one of the included nut
plates such that the tab sticks out. Screw the bolt
into the plate.
FB22136
Jeep® ’07-’18 JK Wrangler
D-Ring Frame Mounts
2
With a 21mm socket and a 22mm wrench, tighten
both bolts, and repeat on the opposite side.
4) INSTALL D-RINGS
Secure the included D-Rings into the mounts.
5) ENJOY YOUR NEW FISHBONE OFFROAD D-RING
FRAME MOUNTS
  • Page 1 1
  • Page 2 2
  • Page 3 3

Fishbone Offroad FB22136 Installation guide

Brand
Fishbone Offroad
Model
FB22136
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents