Thermalright K8 Installation guide

Thermalright
Brand
Thermalright
Model
K8
Category
Hardware cooling accessories
Type
Installation guide
www.thermalright.com
(pic. 3)
4B
2D
blue rubber
strips
(pic. 2)
XP-90 parts list
Parts List
HSF Body with 2 mounting clips
White Rubber vibration damper strips
80 mm fan wire clips
90 / 92 mm fan wire clips
Thermal paste in syringe
K8 Adaptive RM
M3 15mm screws
Quantity
1
2
2
2
1
1
2
K8 installation for XP-90
1. Remove stock RM by unscrew both Philip screws and drip
a couple drops of nail polish remover on the sides of RM to
unglue it from the motherboard, this way RM can be easily
removed without damage PCB and components.
2. Put a thin, even layer of thermal grease on both CPU IHS
and HSF base.
3. Place the included K8 Adapting RM around CPU and use
enclosed M3 15mm screws 8A/B to secure the adapting
RM into stock backplate.
4. Hook the retention hooks 5/6 A into K8 Adapting RM holes
7 A/B, use them as leverage point and gently push HSF
down into RM. Hold the HSF down.
5. Use a small flat screw driver, and hook 5/6 B into RM holes
7 C/D. Slightly rotate the HSF for optimal contact with
CPU IHS.
6. Hook fan wire clip 2 C/D into holes 4A/B, do the same with
fan clip 3C/D to 4C/D. (pic. 2)
7. Put enclosed white rubber strips on the side of HSF fins to
damper the fan vibration. (pic. 3)
8. Place the 80/90/92 mm fan of your choice on top rubber
strips over the Heatsink fins. Hook fan wire clips 2A/B to
lower fan casing screw holes 1A/B, 3 A/B to lower fan
casing screw holes 1C/D.
XP-90
Installation Guide
XP-90
Installation Guide
1D
1A
1B
2D
5B
7C
5A
4B
7A
7B
4D
7D
3A
2A
2C
2B
3C
3B
3D
6B
Top View
Side View
8A
8B
  • Page 1 1

Thermalright K8 Installation guide

Thermalright
Brand
Thermalright
Model
K8
Category
Hardware cooling accessories
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents