2. sensolus
  3. TRACK 1000
TRACK 1000

sensolus TRACK 1000 User guide

  • Hello! I've reviewed the user manual for the tracker 1020. This document provides a detailed guide on how to replace the battery. It includes steps for disassembling the device, replacing the battery pack, and reassembling the tracker, with a useful tip for using a power drill. Also, it gives instructions on how to indicate a battery replacement in the platform. I'm ready to answer your questions about the tracker and this procedure.
  • What is the first step in replacing the battery?
    What should I be careful about when adding a new battery?
    What indicates that the battery pack is connected?
www.sensolus.com | [email protected]om
TRACK 1020 Battery replacement manual
Step 1
• Turn the tracker face down.
• Unscrew the 6 screws.
Tip: If using a power drill, use power seng 7, on low. (Note:
not all power drills have the same sengs!)
Step 2
Remove the back plate and the 6 screws.
Step 3
Remove the circuit board and the baery pack.
Step 4
Turn around the circuit board and baery pack
Step 5
Remove the baery pack - pull them out of the
connector.
Step 6
Add a new baery pack, be carefull with the connector.
A green LED will blink when the baery pack is
connected.
Step 7
Reinsert the circuit board and baery pack.
Make sure the LED is facing downward and the foam on
the baery is facing upwards.
Step 8
Close the case again by ghtening the 6 screws in the
corresponding holes. Be careful not to break the casing
when using a power drill.
www.sensolus.com | [email protected]om
Indicate baery replaced in plaorm
When you replaced the battery in the tracker you have to indicate
thet in the platform.
• Go to the tracker details page in the general secon. You can
search for this tracker or nd in in the asset list or asset map.
• Click on the replace baery link to indicate you have replaced the
baery of that tracker.
• Conrm the update.
/