2. Kentrol
  3. Polished Stainless Steel Mirror Kit

Kentrol Polished Stainless Steel Mirror Kit Installation guide

  • Hello! I have reviewed the Installation Instructions for the KENROL Mirror Kit models 30475 and 50475. This document provides guidance for mounting the mirrors to your vehicle's upper door hinge, using stainless steel fasteners, adjusting the mirror head, and performing maintenance. I am ready to address any questions you may have throughout the installation process.
  • What type of fasteners should be used to mount the mirrors?
    What should I use on the threads of the stainless bolts?
    What should I do if the mirror won't pivot?
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
Part No. 30475 & 50475 Mirror Kit
Instructions:
Locate and mount Mirrors to Upper Door Hinge using the Stainless Steel
Fasteners provided with this kit. We recommend that you use anti-sieze
on all threads of the stainless bolts provided with your parts.
Once Mirrors are bolted to the Upper Door Hinge, sit in the Drivers Seat
and with help set the position of the Mirror Head so you can see both
Mirrors.
• Using a 3/8” box wrench tighten both Hex Head Bolts located on the
bottom of the Mirror Head.
Part No. 30475 & 50475
Clean and wax your mirror
weekly to preserve the high
luster finish.
Note: If mirror will not pivot,
for ad
j
ustin
g
loosen nut at the
bottom. Make sure nut is
tightened otherwise mirror
will vibrate.
Mirror Kit
Instructions:
Locate and mount Mirrors to Upper Door Hinge using the Stainless Steel
Fasteners provided with this kit. We recommend that you use anti-sieze on
all threads of the stainless bolts provided with your parts.
Once Mirrors are bolted to the Upper Door Hinge, sit in the Drivers Seat
and with help set the position of the Mirror Head so you can see both
Mirrors.
* Using a 3/8” box wrench tighten both Hex Head Bolts located on the
bottom of the Mirror Head.
Clean and wax your mirror
weekly to preserve the high
luster finish.
Note: If mirror will not pivot,
for ad
j
ustin
g
loosen nut at the
bottom. Make sure nut is
tightened otherwise mirror
will vibrate.
/