2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. FSR
  6. CB-224FAN

FSR CB-224FAN Installation guide

  • Hello! I've reviewed the installation instructions for the FSR CB-224 and CB-224P Fan Kits. This document provides steps on how to properly install the fan kits, detailing removal of existing parts and secure fan mounting using screws and mounting tabs. I'm ready to answer your questions about the installation process or any other aspects of these fan kits.
  • What should be removed for model CB-224 before installing the fan kit?
    What should be removed for model CB-224P before installing the fan kit?
    What type of screws are used to install the fan kit mounting bracket?
    How many turns should the screws be installed initially into the fan mounting bracket?
FSR 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43967 LIT1367
CB-224 FAN KIT INSTALLATION INSTRUCTIONS
FOR MODEL CB-224 REMOVE DOOR (REFER TO DOCUMENT LIT1364 INCLUDED WITH CB-224) AND
OUTLET GRILL (SEE BELOW). FOR MODEL CB-224P REMOVE DOOR AND POLE MOUNT ASSEMBLY
(REFER TO DOCUMENT LIT1365 INCLUDED WITH CB-224P). INSTALL FAN KIT ASSEMBLY AS SHOWN.
PLUG FAN POWER SUPPLY. RE-ASSEMBLE CEILING BOX.
ROTATE ASSEMBLY AS SHOWN SO SCREWS OF THE
FAN BRACKET SLIP INTO THE SLOTS IN BOTH
MOUNTING TABS. ENSURE THE FAN BRACKET SIDE
TABS ENGAGE THE CAPTURE FEATURES ON THE
POWER OUTLET BOX AND THE KNOCKOUT BRACKET.
2.1. INSTALL (2) #8-32 x 3/8"-LONG PAN HEAD SCREW
INTO FAN MOUNTING BRACKET (2 TURNS ONLY).
ORIENT FAN KIT ASSEMBLY AS SHOWN AND PUSH
ASSEMBLY UP TO KNOCKOUT BRACKET ANGLED
EDGE.
SECURE FAN KIT ASSEMBLY TO KNOCKOUT BRACKET
BY TIGHTENING THE (2) #8-32 x 3/8"-LONG PAN HEAD
SCREWS.
3.
(2) #8-32 x 3/8"-LONG
PAN HEAD SCREW
DIRECTION
OF SECTION
#8-32 x 1/4"-LONG
PAN HEAD SCREW OUTLET GRILL
(CB-224 ONLY)
FAN KIT ASSEMBLY
(2) #8-32 x 3/8"-LONG
PAN HEAD SCREW
AC BOX
CB-224 OR CB-224P
KNOCKOUT BRACKET
DROP-DOWN
RACK-MOUNT
CARRIAGE
(2) #8-32 x 3/8"-LONG
PAN HEAD SCREW
FAN MOUNTING BRACKET
FAN KIT ASSEMBLY
CAPTURE
NOTCH IN
KNOCKOUT
BRACKET
TAB FOR SECURING
FAN KIT ASSEMBLY TO
KNOCKOUT BRACKET
POSITION TOP OF FAN
MOUNTING BRACKET
TAB TO THIS LOCATION
FAN MOUNTING
BRACKET TAB
ANGLED EDGE
/