AGI MKX2, MKX 16 Series Low Profile Hopper Tarp Assembly Manual

Brand: AGI

Model: MKX2, MKX 16 Series Low Profile Hopper Tarp

Type: Assembly Manual

30959 R2

Revised: MAY 2023 1

A305

Low Profile Hopper Tarp

Portable Grain Auger

Installation Instructions

This manual applies to:

AGI Westfield MKX2, MKX 16 Series

AGI X2, X 16 Series

AGI Hutchinson HX2, HX 16 Series

AGI Mayrath HX2, HX 16 Series

Attaching the Hopper Tarp

1. Attach three tarp supports by locking them into

place on both ends and in the centre of the hopper

shield mesh. The tarp supports form a peak in the

tarp for better water run-off.

2. Pull the tarp over the hopper and secure it with

two elastic cords fastened end-to-end around the

bottom of the swing tube, then hooked into the

tarp grommets.

3. For transport with the tarp on, shift the front

corner of the tarp just enough to connect the

hopper lift cable.

Note

The tarp and tarp supports must be removed during hopper use.

AGI is a leading provider of equipment solutions for agriculture bulk commodities including seed, fertilizer, grain, and feed systems with a growing platform in providing

equipment and solutions for food processing facilities. AGI has manufacturing facilities in Canada, the United States, the United Kingdom, Brazil, South Africa, India and Italy

and distributes its products globally.

P.O. Box 39, Rosenort, Manitoba, R0G 1W0 Canada

P866.467.7207 (Canada & USA) or 204.746.2396 │ F866.768.4852 │ E[email protected]

AGGROWTH.COM aggrowthintl