4 of 6
ISSUED: 03-13-12 SHEET #: 125-9287-2 04-03-12
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800-865-2112 or 708-865-8870.
300 mm x 300 mm hole pattern or less: Attach cross supports (E) to back of display using four
M6 x 30 mm socket pin screws (N), M6 x 25 mm socket pin screws (O) or M8 x 25 mm socket pin screws (P)
as shown in gure 3.1 using four .344” ID X .75” OD X .5” spacers (M), with at washers (Q).
400 mm wide hole pattern: Attach adapter brackets (C and D) to back of display using four
M6 x 12 mm socket pin serrated washer head screws (H) or M8 x 15 mm socket pin screws (I)
as shown in gure 3.2.
300 mm x 300 mm DISPLAY SHOWN
400 mm x 400 mm DISPLAY SHOWN
3
Attaching Adapter Bracket to Display
NOTE: For displays using 400 mm wide hole pattern skip to step 3 - 1 gure 3.2
Determine Display mounting hole pattern using adapter bracket assembly detail.
Attach two cross supports (E) to adapter brackets (C and D) using four M8 x 15 mm socket pin screws (I).
I
E
C
D
FRONT VIEW
200 mm
300 mm
100 mm
ADAPTER BRACKET ASSEMBLY DETAIL
400 mm x 400 mm DISPLAY HOLE PATTERN
H or I
DISPLAY
D
C
NOTE: Cross support (E) is not used
300 mm x 300 mm DISPLAY OR SMALLER SHOWN
FIGURE 3.1 FIGURE 3.2
3 - 1
300 mm
200 mm
100 mm
N, O
or P
DISPLAY
E
M
NOTE: Only use at washer (Q) when mounting using
M6 screws (N or O).
Q
DISPLAY
Q
N or O
M
E
