Channel Vision P-1205 is an IR distribution hub that provides power and IR signals to receivers and emitters, allowing you to control devices in different parts of your home or business with just one remote control. It supports up to 16 IR receivers and 4 emitter outputs, with both mini plug and 3-wire connection options for receivers. The P-1205 also features multiple IR zones for independent control of devices from the same manufacturer.
Channel Vision P-1205 is an IR distribution hub that provides power and IR signals to receivers and emitters, allowing you to control devices in different parts of your home or business with just one remote control. It supports up to 16 IR receivers and 4 emitter outputs, with both mini plug and 3-wire connection options for receivers. The P-1205 also features multiple IR zones for independent control of devices from the same manufacturer.
CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in
material or workmanship which occurs during normal use of this
product with new or rebuilt parts, free of charge in the USA, for two
years from the date of original purchase. This is a no hassle warranty
with no mail in warranty card needed. This warranty does not cover
damages in shipment, failures caused by other products not supplied
by Channel Vision Technology, or failures due to accident, misuse,
abuse, or alteration of the equipment. This warranty is extended only
to the original purchaser, and a purchase receipt, invoice, or other
proof of original purchase date will be required before warranty
repairs are provided.
Mail in service can be obtained during the warranty period by calling
(800) 840-0288 toll free. A Return Authorization number must be
obtained in advance and can be marked on the outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other
rights (which vary from state to state). If a problem with this product
develops during or after the warranty period, please contact Channel
Vision Technology, your dealer or any factory-authorized service
center.
500-07
3
rev E
Specifications:
Maximum distance to emitters:
(typical)
500 ft.
Power Supply Voltage:
IR Frequency range supported:
Maximum number of targets:
12 VDC
30 kHz - 56 kHz
16
Specifications subject to change without notice.
IR distribution hub
P-1205
CVHANNEL ISION
TM
© 2004 Channel Vision Technolo
gy
234 Fischer Avenue Costa Mesa, CA 92626
(714) 424-6500 (800) 840-0288 (714) 424-6510 fax
www.channelvision.com email: sales @ channelvision.com
·
··
·
IR Receiver
Model
P-1205
Pwr
Expansion
Global
Zone
Zone
Global
Emitters
+12DC
IR
Receiver
C
V
HANNEL
ISION
TM
C
V
HANNEL
ISION
TM
C
V
HANNEL
ISION
TM
2
The distribution hub supplies power to any standard IR receiver
and IR signals to 4 emitter outputs (2 global, and 2 zone specific).
P-1205
Global IR emitters will flash when any
IR receiver in the system detects a signal.
Zone IR emitters will only flash when an
IR receiver the same P-1205 detects a
signal.
Power connection.
Expansion connectors are used to hook up
additional units and create more IR zones.
Status LEDs.
IR receivers can be connected using either
the 3-wire terminals or mini-plug.
IR repeating concepts:
IR zones:
Most people are familiar with Infra-Red remote controls because they use
them to operate their TV and other devices on a daily basis. However,
some people may not be familiar with IR repeating. IR repeating allows
the user to control devices which are not within the direct line of sight of
the remote control. This is most commonly used in distributed audio/video
systems where the source components are centrally located. See
on the next page for details.
Some IR systems, including the P-1205, are capable of creating zones that
only repeat the IR signals that are picked up by a particular receiver (or
group of receivers). This is useful when there are multiple devices from
the same manufacturer, such as satellite decoders, that are operated with
the same remote control. IR zones prevent one user from inadvertently
control a satellite decoder that someone else is trying to watch.
How IR
repeating works
!
!
!
Multiple IR zones can be created with additional units
Single power supply can support up to 16 IR receivers
Both mini plug and 3-wire connection for receivers
IR Receiver
Model
P-1205
Pwr
Expansion
Global
Zone
Zone
Global
Emitters
+12DC
IR
Receiver
C
V
HANNEL
ISION
TM
C
V
HANNEL
ISION
TM
The from Channel
Vision’s Pro-series product line is
the perfect home for the P-1205.
The P-1300 is a hinged plate
designed to fit into a standard 19”
rack.
NEW P-1300
The hinges open to
maintain a clean look and
provide easy access for
servicing equipment.
P-1300
The P-1205 can also be mounted in a standard structured wiring enclosure
as shown below.
Mounting Options
IR R
eceiver
M
o
d
e
l
P
-1
2
0
5
P
w
r
E
x
p
a
n
s
io
n
G
lo
b
a
l
Z
o
n
e
Z
o
n
e
G
lo
b
a
l
E
m
i
t
t
e
r
s
+
1
2
D
C
IR
R
e
c
e
iv
e
r
C
V
HANNEL
ISION
TM
C
V
HANNEL
ISION
TM
Model
P-1205
Zone
Global
Pwr
Expansion
Emitters
+12DC
IR
Receiver
Global
Zone
IR Receiver
Sig
+V
C
V
HANNEL
ISION
TM
C
V
HANNEL
ISION
TM
7
IR Receiver
Model
P-1205
Pwr
Expansion
Global
Zone
Zone
Global
Em
itters
+12DC
IR
Receiver
C
V
HANNEL
ISION
TM
C
V
HANNEL
ISION
TM
IR Receiver
Model
P-1205
Pwr
Expansion
Global
Zone
Zone
Global
Em
itters
+12DC
IR
Receiver
C
V
HANNEL
ISION
TM
C
V
HANNEL
ISION
TM
Zoned IR Setup
Sat radio
DVD player
Sat radio
DVD player
Receiver
Zone A
(Bedroom 1)
Zone A devices
Zone B devices
Global device
Zone B
(Bedroom 2)
Only 1 power supply
is needed.
The diagram shown above, will create 2 IR zones that will allow for
independent control of identical devices from the same manufacturer.
The zone IR emitters will only respond to signals from the IR receiver
that is in the same zone. The global IR emitters will respond to
signals from any IR receiver in the system.
6
3
How IR repeating works
AB-
500
Tx Batt
Rew<< Play> FF>>
Learn
Stop
Pause
12
3
4
5
6
7
89
0
Power
-/--
Ch
Vol
Learn
Error
All Off
Off
Select
Tuner
CD Sat
VCR
DVD TV
Channel Vision
TM
Point any
IR remote control
at the IR receiver
The IR receiver is wired to
the IR hub which routes the
signal to IR emitters
CD player
And the emitter
repeats the IR signal
in the other room.
Be sure the emitter is attached directly
over the component’s IR receiver.
Other IR components
IR-3003... Single head IR emitter with expansion
jack. As many as 3 units can be chained
together and connected to a single emitter
output.
AB-500
Tx Batt
Rew<<
Play>
FF>>
Learn
Stop
Pause
1
2
3
4
5
6
7
8
9
0
Power
-/--
Ch
Vol
Learn
Error
All Off
Off
Select
Tuner
CD
Sat
VCR
DVD
TV
ChannelVision
TM
AB500 ... Universal remote control. Learns IR
codes for up to 6 sources.
C-1201 ... IR receiver connecting block. Allows
8 IR receivers to be connected in parallel so that
one set of wires can be connected to the P-1205
IR-2301 ... Table top IR Receiver. Can be
placed on any flat surface such as a TV or
entertainment center.
IR-2105 ... Stick type IR receiver with variable
field of view. An adjustable blinder swivels
around the IR pickup to prevent interference
from light sources that may cause erroneous IR
signals.
IR-2202 ... Tube type IR receiver with variable
field of view. The IR pickup slides in and out of
the tube to adjust the field of view.
CVHANNEL ISION
TM
Central
C-1201
IR Receiver
Model
P-1205
Pwr
Expansion
Global
Zone
Zone
Global
Emitters
+12DC
IR
Receiver
C
V
HANNEL
ISION
TM
C
V
HANNEL
ISION
TM
Sat radio
DVD player
CD player
Receiver
Basic IR Setup
A basic IR system, like the one shown below, is often used when
audio/video devices are stored inside a closed cabinet and are out of
the line of sight. The IR receiver is placed outside the cabinet so that
the remote control can be point directly at it. It will detect the IR
signals and route to the P-1205, which in turn sends them to the
emitter outputs.
AB-500
Tx Batt
R
ew
<<
P
lay>
FF>>
Learn
Sto
p
Pause
12
3
4
5
6
7
89
0
P
ow
er
-/--
Ch
Vol
Learn
Error
All Off
O
ffSelect
Tuner
CD Sat
V
CR
DV
D
TV
ChannelVision
TM
4
The diagram above illustrates how to create an IR system with IR
receivers in several different rooms in the house. Systems like this
may include several different styles of IR receivers depending on the
specific application in each room.
IR
R
eceiver
Model
P-1205
Pwr
Expansion
Global
Zone
Zone
Global
Emitters
+12DC
IR
Receiver
C
V
HANNEL
ISION
TM
C
V
HANNEL
ISION
TM
Whole-House IR Setup
5
CVHANNEL ISION
TM
Central
C-1201
Sat radio
DVD player
CD player
Receiver
AB-500
Tx Batt
Rew<< Play>
FF>>
Learn
Sto
p
Pause
12
3
4
5
6
7
89
0
Power
-/--
Ch
Vo
l
Learn
Error
AllOff
Off
Select
Tun
er
CD
Sat
VCR
DVD
TV
Channel Vision
TM
Bedroom 1
Bedroom 2
Bedroom 3
Additional IR receivers
can be connected as
needed.
-
1
-
2
-
3
-
4
Channel Vision P-1205 is an IR distribution hub that provides power and IR signals to receivers and emitters, allowing you to control devices in different parts of your home or business with just one remote control. It supports up to 16 IR receivers and 4 emitter outputs, with both mini plug and 3-wire connection options for receivers. The P-1205 also features multiple IR zones for independent control of devices from the same manufacturer.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- italiano: Channel Vision P-1205 Manuale utente
Related papers
-
Channel Vision P-1205 Datasheet
-
Channel Vision C-0214 User manual
-
-
-
-
-
-
-
-
Other documents
-
Russound CAV6.6-S2 User manual
-
Wyrestorm MX-0808-PP-pOH-4K User manual
-
-
Vaux Electronics Aris 700 User manual
-
B&K CT602 User manual
-
-
Xantech RP41AV User manual
-
SpeakerCraft MZC-66 Installation Instructions Manual
-
Integra MZA-4.7 User manual
-
