Whalen SAV9PCH User manual

Brand
Whalen
Model
SAV9PCH
Type
User manual
Bayside Furnishings
®
Factory No. 17102
Date 2015-03-21 Rev. 3 Factory: GLOCVI
E
Savonne 9 piece Counter Height Dining Set
ITM. / ART. 844024 (U.S., Costco.COM, Taiwan)
ITM. / ART. 924710 (Mexico, CostcoMX.COM)
Model # SAV9PCH
ASSEMBLY INSTRUCTIONS
IMPORTANT, RETAIN FOR FUTURE REFERENCE:
READ CAREFULLY
If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the
store where it was purchased. Please call our toll-free customer service number and have your
instructions and parts list ready to provide the model name, part name or factory number:
1-877-494-2536 (English, French and Spanish)
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday to Friday
(in the US and Canada only)
Or visit our website www.baysidefurnishings.com
Or e-mail your request to parts@baysidefurnishings.com
LOT NUMBER:
DATE PURCHASED:
/ /
ITM. / ART. 844024 & 924710
Bayside Furnishings
®
Page 2
E
1. Please read the Assembly Instructions prior to assembling the unit.
2. This product contains small parts, which are for adult assembly only. Keep small children away
when assembling.
3. To avoid damage, assemble the unit on a sturdy, level and non-abrasive surface.
4. Please wait until all steps are completed before fully tightening bolts.
5. Make sure all bolts and screws are tightly fastened before the unit is used.
6. Check that all bolts, screws and knobs are tight at least every 3 months or as needed.
1. Maximum load weight on table is 181.4 kg / 399.9 lb
MAXIMUM RECOMMENDED WEIGHT LOADS
THIS UNIT IS INTENDED FOR USE ONLY WITH THE MAXIMUM
WEIGHTS INDICATED. USE WITH LOAD HEAVIER THAN THE MAXIMUM
WEIGHTS INDICATED MAY RESULT IN INSTABILITY CAUSING POSSIBLE INJURY.
GENERAL INFORMATION, TIPS & TRICKS
Choking hazard – It contains small parts. Keep all hardware out of
reach of children!
ITM. / ART. 844024 & 924710
Bayside Furnishings
®
Page 3
E
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A- Table Top (1x)
B- Outer Leg (2x) C- Inner Leg (2x)
(With one Female Plastic Fitting)
D- Stretcher (1x) E- Mounting Board (2x) F- Tenon Attachment (2x)
AA- Bolt BB- Large Lock Washer CC- Large Flat Washer
(16x+1 extra) (20x+1 extra) (16x+1 extra)
DD- Bolt (4x+1 extra) EE- Small Flat Washer (4x+1 extra)
Allen Wrench (1x) Touch-up Pen (1x)
Tools required: Allen wrench (included).
ITM. / ART. 844024 & 924710
Bayside Furnishings
®
Page 4
E
Assembly Instructions
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. Combine one Outer Leg (B) and one Inner Leg (C) together by fitting the cutouts properly.
3. Attach the leg assembly to the Stretcher (D) by threading two Bolts (DD) with Lock Washers (BB) and
Small Flat Washers (EE) through the countersunk holes on the Outer Leg (B) and then screw into the
threaded inserts on the Stretcher. Tighten the bolts with the enclosed Allen Wrench.
4. Repeat the same procedure to attach the other two Legs (B and C) to the Stretcher (D) at the opposite
end. Make sure that the threaded holes on the top of each Leg point upward.
DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are
ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.
B
C
D
DD
BB
EE
B
C
C
B
DD
BB
EE
ITM. / ART. 844024 & 924710
Bayside Furnishings
®
Page 5
E
Assembly Instructions
5. Align the center holes of one Mounting Board (E) with the locator dowels on the top of Legs (B and C)
and press them together. Insert four Bolts (AA) with Lock Washers (BB) and Large Flat Washers (CC)
through the countersunk holes of the Mounting Board (E) and securely screw into the Legs (B and C).
As shown.
6. Repeat the same procedure with the other Mounting Board (E).
7. Attach the Tenon Attachment (F) to cover the countersunk holes on each Outer Leg (B) by engaging the
plastic fitting as shown.
B
C
C
B
E
E
B
F
AA
BB
CC
AA
BB
CC
AA
BB
CC
AA
BB
CC
ITM. / ART. 844024 & 924710
Bayside Furnishings
®
Page 6
E
Assembly Instructions
8. Place the Table Top (A) upside down on a level and protective surface as shown.
9. Flip the assembled base upside down and align the drilled holes on Mounting Boards (E) with the
threaded inserts on the slide supports on the Table Top (A). Insert eight Bolts (AA) with Lock Washers
(BB) and Large Flat Washers (CC) through the drilled holes on the Mounting Boards (E) and then
securely screw into the slide supports, using the enclosed Allen Wrench.
E
E
A
AA
BB
CC
AA
BB
CC
AA
BB
CC
AA
BB
CC
ITM. / ART. 844024 & 924710
Bayside Furnishings
®
Page 7
E
Assembly Instructions
10. Ask for assistance to lift the unit upright and position it at the desired location.
11. Unlock the sash locks underneath the Table Top (A) and release the slide locks on both slide mechanisms to
allow the slide to operate, then pull the Table Top wide open equally from both ends.
12. Lift the Butterfly Leaf from the compartment of the Table Top (A). Flip up the leaf and rest it on one
slide support. Unfold the leaf aprons carefully.
13. Unfold the leaf and rest the top flap onto the other slide support.
14. Push the Table Top (A) from both ends to close and lock the sash locks underneath the Table Top. Flip
down the black toggle on each slide mechanism to lock the slides in place.
ON
OFF
ON
OFF
ITM. / ART. 844024 & 924710
Bayside Furnishings
®
Page 8
E
To Store the Butterfly Leaf When Not In Use
15. Unlock the sash locks underneath the Table Top (A) and release the slide locks on both slide mechanisms
to allow the slide to operate, then pull the Table Top wide open equally from both ends.
16. Fold two Center Leaves together and flip down the leaf aprons.
17. Rotate the Center Leaves and rest them onto the leaf support as shown.
18. Push the Table Top (A) from both ends to close. Lock the sash locks underneath the Table Top and flip
down the black toggle on each slide mechanism to lock the slides in place.
ON
OFF
ON OFF
ITM. / ART. 844024 & 924710
Bayside Furnishings
®
Page 9
E
Care and Maintenance
Use a soft, clean cloth that will not scratch the surface when dusting.
Use of furniture polish is not necessary. Should you choose to use polish, test first in an inconspicuous area.
Using solvents of any kind on your furniture may damage the finish.
Never use water to clean your furniture as it may cause damage to the finish.
Always use coasters under beverage glasses and flowerpots.
Liquid spills should be removed immediately. Using a soft clean cloth, blot the spill gently. Avoid rubbing.
Always use protective pads under hot dishes and plates. Heat can cause chemical changes that may create
spotting within the furniture finish.
Stains or marks from crayons or ink markers will be difficult to remove.
In the event that your furniture is stained or otherwise damaged during use, we recommend that you call a
professional to repair your furniture.
Check bolts/screws periodically and tighten them if necessary.
Further advice about wood furniture care
It is best to keep your furniture in a climate-controlled environment. Extreme temperature and humidity
changes can cause fading, warping, shrinking and splitting of wood. It is advised to keep furniture away from
direct sunlight as sun may damage the finish.
Proper care and cleaning at home will extend the life of your purchase. Following these important and helpful
tips will enhance your furniture as it ages.
A touch-up pen has been provided to repair any small nicks or scratches that may occur during
assembly or shipping.
We hope you enjoy your purchase for many years.
Thank you for choosing Bayside Furnishings
®
!
QUALITY GUARANTEE
(Warranty not valid in Mexico)
We are confident that you will be delighted with your Bayside Furnishings
®
purchase.
Should this product be defective in workmanship or materials or fail under normal use, we will repair or
replace it for up to one (1) year from date of purchase. Every Bayside Furnishings
®
product is designed to meet
your highest expectations. We guarantee that you will immediately see the value of our fine furniture.
This warranty gives you specific legal rights and you may also have other rights which vary from State to State.
AUSTRALIA: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be
of acceptable quality and the failure does not amount to a major failure.
Customer Service: 1-877-494-2536 (English, French and Spanish)
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday to Friday
(in the US and Canada only)
www.baysidefurnishings.com
MADE IN VIETNAM / FABRIQUÉ AU VIETNAM / HECHO EN VIETNAM
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Whalen SAV9PCH User manual

Brand
Whalen
Model
SAV9PCH
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents