Jegs 2014-2015 User manual

Brand: Jegs

Model: 2014-2015

Type: User manual

INSTALLATION INSTRUCTIONS | PART NO. 106-0102

BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056

Technical Support: 1-800-631-7271

When working on, under, or around any vehicle exercise cauon.

Please allow the vehicle's exhaust system to cool before removal, as

exhaust temperatures may cause severe burns. If working without a

li, always consult vehicle manual for correct liing specicaons.

Always wear safety glasses and ensure a safe work area. Serious injury

or death could occur if safety measures are not followed.

WARNING:

BRExhaust recommends

professional installaon

for all products

www.brexhaust.com

STEP 1:

(Carefully read all instrucons before installaon) Disconnect the

vehicle’s baery before removal of the OEM exhaust system. This

will prevent electrical accidents and will reset the computer if it

applies to the vehicle. Remove exisng exhaust system from the

vehicle. Only remove parts that will be replaced. Clean exisng

ange with a wire brush to ensure proper sealing.

STEP 2:

Aach item 2 to exisng exhaust with item 1 (nuts and bolts not

included)

STEP 2A:

Use item 7 and 6 with resonator for 12-13 model year

STEP 3:

Aach item 5 to exisng isolators and item 2 with items 3 and4

STEP 4:

Connect slip t joint on item 2 with clamps provided

STEP 5:

Ensure new exhaust is not contacng any poron of the

underbody of the vehicle or drivetrain.

STEP 6:

Tighten all clamps starng from rear of the vehicle. (DO NOT

EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL

CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)

BILL OF MATERIALS:

1. 167588

2. 169507

3. 167602

4. 167860

5. 167722

6. 167744

7. 169522

1

2

7

3

2

4

5

6

2

1

Jegs 2014-2015 User manual

Brand: Jegs

Model: 2014-2015

Type: User manual

Related papers

Other documents