Page is loading ...
INSTALLATION INSTRUCTIONS | PART NO. 106-0463
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
Technical Support: 1-800-631-7271
When working on, under, or around any vehicle exercise cauon.
Please allow the vehicle's exhaust system to cool before removal, as
exhaust temperatures may cause severe burns. If working without a
li, always consult vehicle manual for correct liing specicaons.
Always wear safety glasses and ensure a safe work area. Serious injury
or death could occur if safety measures are not followed.
WARNING:
BRExhaust recommends
professional installaon
for all products
www.brexhaust.com
STEP 1:
(Carefully read all instrucons before installaon) Disconnect the
vehicle’s baery before removal of the OEM exhaust system. This
will prevent electrical accidents and will reset the computer if it
applies to the vehicle. Remove exisng exhaust system from the
vehicle. Only remove parts that will be replaced. Clean exisng
ange with a wire brush to ensure proper sealing.
STEP 2:
Aach item 2 to exisng exhaust using item 1
STEP 3:
Connect item 4 to item 2 with item 3
STEP 4:
Connect item 5 to item 4
STEP 5:
Connect slip t on item 2 with clamp provided
STEP 6:
Ensure new exhaust is not contacng any poron of the
underbody of the vehicle or drivetrain.
STEP 7:
Tighten all clamps starng from rear of the vehicle. (DO NOT
EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL
CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)
BILL OF MATERIALS:
1. 169305
2. 168575
3. 167503
4. 168574
5. 167639
1 2
2
2
3 4
5
/
