BRExhaust 106-0018 Installation guide

Brand: BRExhaust

Model: 106-0018

Type: Installation guide

INSTALLATION INSTRUCTIONS | PART NO. 106-0018

BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056

Technical Support: 1-800-631-7271

When working on, under, or around any vehicle exercise cauon.

Please allow the vehicle's exhaust system to cool before removal, as

exhaust temperatures may cause severe burns. If working without a

li, always consult vehicle manual for correct liing specicaons.

Always wear safety glasses and ensure a safe work area. Serious injury

or death could occur if safety measures are not followed.

WARNING:

BRExhaust recommends

professional installaon

for all products

STEP 1:

(Carefully read all instrucons before installaon) Disconnect

the vehicle’s baery before removal of the OEM exhaust

system. This will prevent electrical accidents and will reset the

computer if it applies to the vehicle. Remove exisng exhaust

system from the vehicle. Only remove parts that will be

replaced. Clean exisng ange with a wire brush to ensure

proper sealing.

STEP 2:

Begin installaon by sliding item 4 together and placing into

isolators. Place clamp aached to item 4 on slip t joint.

STEP 3:

Aach item 2 to currently installed exhaust and item 3

STEP 3A:

Use item 3 and 5 for 4.7L engine

STEP 4:

Place item 3 between item 2 and 4.

STEP 5:

Install item 1 on the inlet of item 2

STEP 6:

Ensure new exhaust is not contacng any poron of the

underbody of the vehicle or drivetrain.

STEP 7:

Tighten all clamps starng from rear of the vehicle. (DO NOT

EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL

CLAMPS AFTER 50 MILES. RETIGHTEN IF NECESSARY)

1

2

3

4

www.brexhaust.com

5

3

1

BRExhaust 106-0018 Installation guide

Brand: BRExhaust

Model: 106-0018

Type: Installation guide

Download PDF

Related papers

Other documents