Whirlpool WME1899 DFC IX Owner's manual

Type
Owner's manual

This manual is also suitable for

1. Lighting
2. Fan with filter (if provided); for the filter, see
the instructions enclosed with it
3. Multi-flow air circulation system
4. Shelves / Shelf zone
5. "Zero Degrees" special compartment
(if available)
6. Rating plate (at the side of crisper)
7. Crisper
8. Control panel
9. Door trays
10. Removable bottle holder (if provided)
11. Bottle holders
Notes: The number of shelves and shape of
accessories may vary, depending on the model.
All the shelves and door trays are removable.
Attention: Do not place the refrigerator
accessories in a dishwasher.
7
4
8
9
11
10
6
1
2
2b
2a
3
5
IGB FINDKNSGRPENLFD
PRODUCT SHEET
GB
FINDKNSGRIPENLFGBD
Refrigerator inside temperature adjustment
The appliance is normally factory-set for operation at the recommended temperature of 5°C.
The inside temperature setting can be adjusted between 3°C and 7°C, proceeding as follows:
Press the inside temperature adjustment button D. The storage temperature can be changed by 1°C
with each press of the button: the value flashes cyclically between 3°C and 7°C.
Vacation mode
The vacation mode function allows a reduction in electric energy consumption in case of prolonged
absence.
The function is activated by pressing the button I for 3 seconds; the LED E lights up and stays on. The
Vacation function is not compatible with the Fast Cool function. To restore normal functioning of the
refrigerator compartment, repeat the operation. After activating the function, remove perishable food
from the refrigerator compartment and keep the door closed, since the refrigerator maintains an adequate
temperature to prevent the formation of odors.
Note: The refrigerator can operate at ambient temperatures between +10°C and +38°C and optimum
performance is obtained at temperatures between +16°C and +38°C.
The ambient air temperature, the frequency of door opening and the position of the appliance
can affect the temperatures inside the refrigerator. Take these factors into consideration when
setting the thermostat knob.
For the complete shutdown of the product, unplug it.
A. 6th Sense. "6th Sense" activation indicator (see
enclosed instructions)
B. On/Standby. Press for at least 3 seconds to
put the product in standby mode. Press the
icon once to reactivate the product.
C. Temperature. Set temperature indicator.
D. Temperature. Temperature setting button
E. Vacation mode. Vacation function on indicator.
(see the specific section)
F. Key Lock. Press for at least 3 seconds to
activate/deactivate the Key Lock. When
activated, pressing the other icons activates an
audible signal.
G. Door open. Door open indicator.
H. Stop alarm. Press in case of alarm.
I. Fast Cool/Vacation mode. Press once to
activate the Fast Cool mode. The function
switches off automatically after about 6 hours.
Press for at least 3 seconds to activate the
Vacation Mode.
CONTROL PANEL
ABCDE
A
B
C
D
E
FGH I
F
G
H
I
FINDKNSGRIPENLFGBD
The fan ensures a uniform temperature inside the refrigerator compartment, for optimum food storage.
To activate the fan, press the corresponding button (2a). It is advisable to switch the fan on when the
ambient temperature exceeds 27 - 28°C, or if water droplets form on the glass shelves, or else in very
humid conditions.
Note: Do not obstruct the front air inlet with food (2b).
The fan will start ONLY when the compressor is working.
Remember to switch off the fan when the ambient temperature decreases.
FAN WITH BUTTON (if available)
ALARM SIGNALING
Signal Cause Cure
Door open alarm The audible alarm is
activated and the light G
remains comes on.
The door has remained
open for more than 2
minutes
Close the door
Malfunction The message "F" flashes
on the display C
Product malfunction Contact the After-Sales
Service
5019 308 01057 Printed in Italy 03/12 - Whirlpool
®
Registered trademark/TM Trademark of Whirlpool group of companies - © Copyright Whirlpool Europe s.r.l. 2012. All rights reserved - http://www.whirlpool.eu
This optional function can be used to save energy.
To activate the Eco mode, press the buttons F and I together for 3 seconds until an audible signal sounds.
Two seconds after activation of the Eco mode, the display goes off, except the "6th Sense" icon (and the
audible signal is deactivated, if on).
To adjust the temperature or use other functions, it is necessary to activate the display by pressing any
button.
After about 15 seconds without performing any action, the display goes off again and only the "6th Sense"
icon remains visible.
To deactivate this function, press the buttons F and I together for 3 seconds until an audible signal sounds.
The normal display is restored.
The Eco mode is automatically disabled after a power failure or a fault alarm. Remember that this function
does not disconnect the appliance from the power supply.
ECO MODE
  • Page 1 1
  • Page 2 2
  • Page 3 3

Whirlpool WME1899 DFC IX Owner's manual

Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI