Bauknecht GKE 1870 A++ Program Chart

Brand: Bauknecht

Model: GKE 1870 A++

Type: Program Chart

Bauknecht GKE 1870 A++ is a freezer that helps you store frozen food, make ice, and preserve the freshness of your food for longer. It features a control panel with a temperature adjustment button, a fast freeze function, and an eco mode to save energy. The freezer also has an alarm system that signals when the door is open, when the temperature is too high, and in case of a power failure.

1. Control panel

2. Ice packs (inside - if provided for)

3. Rating plate (at side of drawer)

4. Freezing compartment

5. Zone for drawers and pull-out

baskets

Storage zone

Freezing zone

Note: The design of drawers and

accessories may vary, depending on

the model.

D GB I FINDKNPENLF SGR

A. Green Intelligence. "Green Intelligence"

activation indicator (See enclosed instructions)

B. On/Standby. Standby button. Press for at least

3 seconds to activate it. Press the icon once to

reactivate the keypad.

C. Temperature. Set temperature indicator.

D. Temperature. Temperature setting button.

E. Key Lock. Key Lock activated indicator. Press

for at least 3 seconds to activate/deactivate the

Key Lock. When activated, pressing the other

icons activates an audible signal.

F. Stop alarm. Press in case of alarm.

G. Black-out alarm. Long Black-out Alarm

indicator. (See the section "alarm signalling").

H. Fast Freeze Fast Freeze on indicator. Press to

activate/deactivate the Fast Freeze function. The

Fast Freeze function switches off automatically

after 48 hours.

CONTROL PANEL

ABCD

EFGH

PRODUCT SHEET

FINDKNSGRIPENLFGBD

Freezer inside temperature adjustment

The appliance is normally factory-set for operation at the recommended temperature of -18°C.

The inside temperature setting can be adjusted between -16°C and -24°C, proceeding as follows:

• Press the inside temperature adjustment button D. The storage temperature can be changed by -1°C with

each press of the button: the value flashes cyclically between -16°C and -24°C.

• The "Green Intelligence" function is activated automatically in case of opening of doors and the introduction

of small amounts of food to be frozen. Its duration is variable and depends on the product load conditions

and the outside temperature. It does not require any intervention by the user and switches off automatically

when normal operating conditions are restored

This optional function can be used to save energy.

To activate the Eco mode, press the buttons E and H together for 3 seconds until an audible signal sounds.

Two seconds after activation of the Eco mode, the display goes off, except the Green Intelligence icon (and

the audible signal is deactivated, if on).

To adjust the temperature or use other functions, it is necessary to activate the display by pressing any

button.

After about 15 seconds without performing any action, the display goes off again and only the Green

Intelligence icon remains visible.

To deactivate this function, press the buttons E and H together for 3 seconds until an audible signal

sounds. The normal display is restored.

The Eco mode is automatically disabled after a power failure or a fault alarm.

Remember that this function does not disconnect the appliance from the power supply

ECO MODE

FINDKNSGRIPENLFGBD

Note: The temperature alarm may even be activated following prolonged opening of the door or after

fresh food products have been placed in the freezing zone; the temporary increase in temperature

signalled does not affect the perfect preservation of already frozen food.

ALARM SIGNALLING

Signal Cause Cure

Door open alarm The audible alarm is

activated.

The door has remained

open for more than 2

minutes

Close the door

Temperature

alarm

The audible alarm is

activated, the set

temperature flashes and

the red light F remains on

The inside temperature is

not adequate

Press the button F; the

audible alarm stops, the

set temperature flashes

and the red light F

remains on until a

temperature < -10°C is

reached.

Long black-out

alarm

The audible alarm is

activated, the light G

remains on, the light F

flashes and the displays

shows the maximum

temperature reached.

Prolonged power

failure, able to cause the

inside temperature to

increase to 0°C

Press the button F; the

audible alarm stops, the

set temperature flashes

and the red light F

remains on until a

temperature < -10°C is

reached.

Malfunction The message "FF" flashes

on the display C

Product malfunction Contact the After-Sales

Service

1. Put the product in standby mode by pressing the button B for at

least 3 seconds.

2. Unplug the appliance or turn off the main switch.

3. Insert the chute (contained in the accessories bag) in the special

slot (see figure).

4. Follow the instructions given in the instruction booklet.

5. Reinsert the plug or turn on the main switch.

6. Reactivate the product by pressing the button B once.

5019 403 01002 Printed in Italy 03/12 - Bauknecht

DEFROST

Bauknecht GKE 1870 A++ Program Chart

Bauknecht GKE 1870 A++ Program Chart

Bauknecht GKE 1870 A++ Program Chart

Related papers

Other documents