Aerix Vidius User manual

Type
User manual
Lithium Battery Warnings:
● Through the use of the included Lithium battery, you have assumed all risk
and responsibility regarding a Lithium battery and its use.
● ALWAYS unplug your battery from the charger immediately upon full charge.
● Do not attempt to charge your battery if it becomes swollen or hot.
● It’s best to store your batteries charged and at room temperature. Storing
a fully discharged battery may cause irreversible damage to the battery.
● Never disassemble, puncture or modify the battery pack in any way.
● Never allow the battery temperature to exceed 150° F [65° C].
● If your battery begins to swell or “puff” during charge or discharge, or
becomes damaged in any way, stop using it and contact Aerix Drones
at 800-610-0605 to learn the proper way to dispose of your battery.
Charge Warnings:
Only use the included charger with the included Lithium battery.
● Do not leave the charger unattended while in use, and always charge your
battery in a fire-resistant location.
● Disconnect the battery and remove input power from the charger immediately
if either become hot.
● Do not allow water or other foreign objects to enter the charger. Keep the
charger away from moisture and do not submerge in water.
● Please keep all electronic components out of the reach of children.
Please read and understand the following regarding the usage of Lithium batteries.
By operating this device you acknowledge and accept all risks
and responsibilities of the use, storage and proper disposal of
any and all included lithium batteries.
You agree to follow the safety precautions outlined below in
addition to any and all state, local or federal laws regarding lithium
batteries.
Axis Drones and its affiliates are not responsible for any misuse.
The Lithium battery included with your device is guaranteed to be free from any
manufacturing defects prior to initial use. Once the device has been used, owner
accepts any and all liability for the Lithium battery, maintenance and disposal.
VIDIUS Drone Spare Blades
USB Charging Cable
WHAT’S IN THE BOX
Fine tuning of forward and backward movement
Throttle - Rotation - Speed Selection
Directional Movement - Trick Mode
Fine tuning of left and right movement
Slow Blink: Not Transmitting
Fast Blink: Attempting to pair
Solid: Paired and Operational
Right: OFF Left: ON
Please be aware of your surroundings when operating your VIDIUS Drone.
As this device can reach high speeds, it is recommended to fly in open areas.
- DO NOT FLY NEAR PEOPLE, ANIMALS OR PROPERTY
- Adult supervision is recommended for users under 18
- Indoor flight should have plenty of open space
- Damage to property or injury to people is a risk, fly safely.
- Always keep the VIDIUS in your line of sight and under 400ft
- If device travels too far away from user it may lose control
- When flying outdoors please do not operate in med-high wind
- Always make sure your VIDIUS is fully charged before flight
- Replace remote control batteries before they become too weak
- Avoid colliding with people, property or animals
Releasing throttle
at high altitude may
result in injury or
damage to device,
people or property.
Always keep device at
a safe distance from
the ground and other
objects.
Please DO NOT fly
in areas with many
obstacles or around
objects that can be
easily damaged.
CHARGING DRONE
INSTALLING BATTERIES IN CONTROLLER
- Connect charging cable to the drone FIRST, then plug the USB side in.
- It is recommended to charge with a computer USB port, not a wall adapter.
- The red light will be ON while charging and OFF when fully charged.
- Promptly remove the cable from both the USB and drone upon full charge.
- DO NOT LEAVE drone unattended while charging.
GETTING STARTED
1. Place the VIDIUS Drone on a flat LEVEL surface and turn drone power on
2. Align joysticks as shown in (Figure 1), Left stick down, right stick center
3. Turn the controller on by sliding the power switch to the left
4. Power Indicator light will begin flashing, indicating it is ready to pair
5. Move left joystick FULLY UP (Figure 2) then FULLY DOWN (Figure 3)
6. Lights on both the VIDIUS and the Controller will remain solid
7. Your VIDIUS and Controller are now paired and ready for flight!
Please load the batteries with the correct polarity, as shown below:
Turn Drone Upside Down to Align Prong
The throttle on the VIDIUS will take some practice to achieve a good hover.
We recommend using your thumb and index finger to make small adjustments
to the throttle stick; you can progress to just your thumb with experience.
The VIDIUS will start out in LOW Speed, please start here to get acquainted.
Moving Left Stick Up/Down controls the Rise/Drop of the VIDIUS Drone
Moving Left Stick Left/Right controls the Yaw (Rotation) to adjust orientation
Left Rotation
Right Rotation
Moving Right Stick Up/Down controls Forward and Reverse Flight Direction
Forward Flight
Reverse Flight
Moving Right Stick Left/Right controls Left and Right Flight Direction
Left Flight
Right Flight
FRONT FLIP
BACK FLIP
ROLL LEFT
ROLL RIGHT
Press Right Stick IN, Controller will beep, Push Right Stick FULL UP
Press Right Stick IN, Controller will beep, Push Right Stick FULL DOWN
Press Right Stick IN, Controller will beep, Push Right Stick FULL LEFT
Press Right Stick IN, Controller will beep, Push Right Stick FULL RIGHT
SPEED SETTINGS
There are 3 unique speed settings programmed into the VIDIUS.
To change speeds at any time simply press the Left Stick IN (Figure 1)
Pressing multiple times allows you to cycle through all of the speeds.
Each speed is indicated by a corresponding number of beeps.
Low Speed:
This is the Default speed everytime you power up,
indicated by a single beep.
Medium Speed:
Indicated by two beeps. Medium speed is twice as fast as low speed
and is able to be used both indoors and outdoors in light winds.
HIGH Speed:
Indicated by three beeps, this is the fastest speed for the VIDIUS Drone.
FLIPS AND ROLLS
The VIDIUS is pre-programmed with an algorithm to perform flips and rolls
with ease, simply press the Right Joystick IN to enter “Trick Mode”
Once in “Trick Mode” - indicated by beeping, simply push the Right Stick
fully in the direction you want to flip or roll! (SEE NEXT PAGE)
Drift Left
Trim Right
Trim Left
Drift Right
Drift Forward
Drift Backward Trim Forward
Trim Backward
Blade A
Blade A
Blade B
Blade B
Power Switch
Charger Port
Camera Lens
Picture/Video Indicator
TROUBLESHOOTING
In the event you have issues with your VIDIUS please check here:
Drone won’t lift off of ground or flips over right away:
1. Check the location of your A&B blades to match page 3.
2. Remove blades, clean all debris from posts and motor base.
3. Make sure your drone and remote batteries are fully charged
4. Check that blades are not bent or damaged, replace as needed
Drone drifts heavily in one direction:
1. Make sure your Trimmer settings are at CENTER (long beep)
2. Make sure all blades are evenly and fully seated on driveshafts
3. Remove blades, clean all debris from posts and motor base.
4. Remove Batteries from Controller for 90 seconds; replace.
5. Restart and Pair Drone and Controller (page 4)
6. If 1-4 did not solve please recalibrate your drone (page 10)
7. If 1-5 did not work please email [email protected] for help.
Controller and Drone won’t connect:
1. Replace the batteries in the controller with BRAND NEW ones
2. Charge the drone and try again (page 4) be sure to turn drone on first.
3. Try to pair VIDIUS via wifi to the Flight App, contact us with results.
Drone won’t hover, keeps going up and down:
1. Use thumb and index finger on throttle to make smaller adjustments
2. Check that blades are not damaged or on incorrectly
One or more lights/motors stopped working:
1. Please contact [email protected] for futher assistance.
Can’t View Live Video on Device:
1. Be sure to turn drone on first, then connect via wifi on your device.
CHANGING BLADES
- To remove blades, firmly grasp the center of the blade and pull UP.
- To replace blades, firmly press the new blade DOWN onto shaft.
- Adjust blades to be straight and even, no bends or twists.
- Location of A&B Blades should always be as shown on page 3.
RECALIBRATION OF ACCELEROMETER
If your VIDIUS begins to be unstable during flight, drifts heavily in
one direction or troubleshooting doesn’t work please do the following:
1. Turn the drone and controller off, and remove batteries
from controller for at least 90 seconds.
2. Leaving the drone and the controller off, replace
batteries in controller.
3. Place drone on flat, level surface
(level is the key word as this sets the gyroscope).
4. Turn drone on.
5. Turn controller on and pair with drone. (page 4)
6. Push the Throttle (Left Stick) to Lower Left, HOLD
7. Push Control (Right Stick) to Lower Right, HOLD
8. Drone will flash for 1-2 seconds indicating success.
9. Take off and see which way the drone pulls, if any.
10. Adjust trim buttons in 2-3 beep increments, in opposite
direction of drone drifting, until it remains steady.
11. If steps did not correct the issue please contact us.
Calibration
In order to view, record and control your VIDIUS Drone from your iOS
or Android device you will need to first download the VIDIUS Drone app.
Please search for “VIDIUS Drone” in your app store or scan code below.
iOS (iTunes) VIDIUS Drone Android (Google Play)
Once downloaded, please turn your VIDIUS Drone on and go to your
device’s wifi menu and connect to “VIDIUS Drone” to begin.
Once connected, open the VIDIUS Drone app and press GO FLY!
You can now view live video and operate the drone from your device,
if you would like to control with the analog controller please press ON
(7) at the top of the screen, which will then turn the phone controls OFF,
then you may turn on the analog controller and pair to the drone.
To record video, press the Video Icon (3), press again to stop recording.
To snap a photo during flight, press the Camera Icon (2) one time.
You can review your videos and photos by pressing the Review Icon (4).
To change speeds while controlling with your device press 30% Icon (5).
To control your drone with your device’s gyroscope press Gyro Icon (6)
Flight controls on your device function the same as the analog controller.
Trim settings can also be adjusted from the app screen as well.
Please Note: Videos will be stored on your device when recorded.
Downloading & Using the VIDIUS Drone App
www.aerixdrones.com
AERIX
AERIX
AERIX
AERIX
AERIX
AERIX
AERIX
  • Page 1 1

Aerix Vidius User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI