Amcrest OB1-M User manual

Brand: Amcrest

Model: OB1-M

Type: User manual

Amcrest Force Hand Drone OB1-M User Manual

Press and hold the power button for

1 to 2 seconds to power off the

drone. The green LED will turn off.

Turn on the drone and hold it in your hand, extend your hand

forward, and then release the drone to start flying.

5. Flying Speed - Medium & High Speed Modes

4. Flight Interaction

3. Flight

2. Shut Down

1. Start Up

Power Button

Flying speeds of the drone are indicated by the color LED that is illuminated.

A green LED light indicates the drone is flying in medium speed. The drone

will be set to medium speed by default.

To increase the speed of the drone to high speed mode, click the power

button. A blue LED light will appear indicating the drone is flying in high speed.

To revert back to medium speed mode, press the power button again.

Press and hold the power button for 1

to 2 seconds to turn on the drone. A

green LED will appear indicating the

drone is on.

The drone will fly upward and begin to hover. If there is no interaction

with the drone for 1 to 2 seconds, the drone will begin to descend and

continue to hover.

Approach the bottom of the drone to allow the drone to ascend upward.

The drone will hover and begin to descend if no interaction is detected.

When a hand or other object approaches the drone, it will move in the

opposite direction of the object once it is detected.

The drone can be affected during flight if it encounters strong light, wind,

obstructions, or glass.

To calibrate your drone, make sure the drone is turned off. Place the

drone on a level surface and then turn the drone on using the power

button.

The indicator light of the drone will begin to flash, red, blue, and green

which indicates the drone is calibrating.

Make sure to keep the drone in a balanced position during calibration.

The green LED light will remain solid after the calibration process has

been completed.

6. Flight Calibration

To stop, grab the drone while in flight. You can also flip the drone

over to stop operation.

7. Stop Flying

8. Charging

When the indicator LED on the top of the drone turns red it means

the drone is running low on battery and needs to be charged.

Charging time for the drone is about 30 minutes. When charging, the

LED on the USB charger will remain solid. When charging complete,

the LED will turn off.

Please use the included USB charging cable to charge the drone.

9. Flight Time

A drone with a fully charged battery can have about 5 minutes of flight

time depending on the flying conditions and overall useage during

operation.

10. Warning

Do not use the drone during high wind or in strong light.

Do not operate the drone in a narrow or cluttered environment.

Do not put any heavy objects directly on the drone.

To charage, connect the USB charger to a USB port on a PC and

connect the other end of the cable to the charge port of the drone.

Amcrest OB1-M User manual

Amcrest OB1-M User manual

Other documents