Lovibond Single Method SD 50 - pH User manual

  • Hello! I'm a chat assistant, and I've reviewed the Method Reference Book for the Lovibond pH Meter SD 50. This document provides instructions on how to properly use the device, including rinsing the electrode before measurement. It also gives instructions on how to immerse the tester in the sample water and indicates the pH range of the device, which is from 0 to 14. I'm ready to answer any questions you have about this device.
  • What should I do before measuring the sample water?
    How should I immerse the tester in the sample water?
    Where can I find more detailed device setup?
pH / SD 50
ENMethod Reference Book1.02
pH SD 50
0 - 14
Application List
Cooling Water
Notes
1. The description of the calibration, the preparation of the buffer solutions and the
device settings are described in the detailed operating instructions.Detailed operating
instructions are enclosed with the device.
pH / SD 50
ENMethod Reference Book1.0 3
pH / SD 50
ENMethod Reference Book1.04
°C pH
Rinse the electrode with
distilled or deionised water
and carefully wipe with a
paper towel.
Hold the tester without
protective cap in the
sample water to be
measured so that the elec-
trode and temperature
probe is immersed in the
sample water not deeper
than the seal ring.
The measurement result is
displayed.
/