2. Lovibond
  3. Single Method SD 335 - Conductivity

Lovibond Single Method SD 335 - Conductivity User manual

  • Hello! I've reviewed the Method Reference Book for the Lovibond SD 335 conductivity meter. This document outlines the necessary accessories, such as the LC 12, and provides measurement instructions including electrode preparation and parameter adjustments. I am ready to answer your questions about the device and its operation.
  • What accessory is required for the SD 335 Conductivity meter?
    What is the maximum conductivity range?
    Can the conductivity measurement be changed to TDS or salinity?
    What should you do before measuring?
Conductivity / SD 335
ENMethod Reference Book1.02
Conductivity SD 335
0 - 200 mS/cm
The following accessories are required.
Accessories Packaging Unit Part Number
LC 12 for SD 320 / SD 325 Con, up to
200 mS/cm
1 pc. 19805040
Conductivity / SD 335
ENMethod Reference Book1.0 3
Conductivity / SD 335
ENMethod Reference Book1.04
10:58
pH
1401 µS/cm
7.01 pH
*** conductivity ***
temperature (O2/con)
23.9 °C
temperature (pH)
23.8 °C
Rinse the electrode with
distilled or deionised water
and then with the sample.
Immerse the measuring
cell in the sample. During
measurement, ensure that
there are no air bubbles on
the electrode surface and
that the electrode, as well
as the temperature sensor,
are sufficiently surrounded
by the sample.
The measurement value can
now be read off from the
display. In the parameter
configuration you can change
the conductivity to TDS or
salinity if required.
/