Halco T896FR42/865/BYP2/RDC/LED Installation guide

Halco
Brand
Halco
Model
T896FR42/865/BYP2/RDC/LED
Type
Installation guide

This manual is also suitable for

ProLED® Double Ended Bypass T8 LED
Installation Instructions
IMPORTANT
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ProLED luminaires must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A QUALIFIED ELECTRICIAN WHO IS
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING -
WARNING - Installers should not disconnect existing wires from lamp holder terminals to make new connections at lamp holder terminals. Instead,
installers should cut existing lamp holder leads away from the lamp holder and make new electrical connections to lamp holder lead wires by
employing applicable connectors.
WARNING
and/or drawings. DO NOT make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING - To prevent wiring damage or abrasion, DO NOT expose wiring to edges of sheet metal or other sharp objects.
WARNING
WARNING - This device is not intended for use with emergency exits.
WARRANTY INFORMATION:
an email or write to the address below for product return and replacement. This replacement is the sole remedy available. Liability for incidental or
consequential damage is expressly excluded. Visit www.halcolighting.com for full warranty details and dimmer compatibility information.
INSTLLATION INSTRUCTIONS:
Please completely comply with these instructions and notes, to ensure that the product is operated in a safe condition.
SAFETY RECAUTIONS:
For your and other’s safety, please read the warnings carefully before installation:
2. Switch off the power supply before commencing to work, make sure the correct connection has power before power on.
3. NOT FOR EMERGENCY LIGHTING.
4. OPERATED WITH METAL LUMINAIRES ONLY.
®
Halco Lighting Technologies
2940 Pacific Drive, Norcross, GA 30071
Toll Free 800.677.3334 | Fax 800.880.0822
halcolighting.com
96"
(2438 mm)
1"
(25 mm)
ProLED® Double Ended Bypass T8 LED
Installation Instructions ®
ProLED® Double Ended Bypass T8 LED
Installation Instructions ®
ProLED® Double Ended Bypass T8 LED
Installation Instructions ®
T896FR43/840/BYP/RDC/LED
T896FR43/850/BYP/RDC/LED
96" (2,438.4mm)L x 1" (25.4mm)
96" (2,438.4mm)L x 1" (25.4mm)
2
2
T896FR43/865/BYP/RDC/LED 96" (2,438.4mm)L x 1" (25.4mm) 2
T896FR43/840/BYP/SP/LED
T896FR43/850/BYP/SP/LED
96" (2,438.4mm)L x 1" (25.4mm)
96" (2,438.4mm)L x 1" (25.4mm)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Halco T896FR42/865/BYP2/RDC/LED Installation guide

Halco
Brand
Halco
Model
T896FR42/865/BYP2/RDC/LED
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents