CURTMFG.COM
•
NEED ASSISTANCE?
•
800.798.0813
•
45907-INS-RA
•
PAGE 1
INSTALLATION MANUAL
45907
Parts List
1 Channel-mount
1 Pintle head
1 Hitch pin & clip
2 Channel-mount pin & clip
1 Rubber anti-rattle bumper
Level of Difficulty
Easy
Notes
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
Before towing, ensure all pins & clips are secured.
Do not overload any part of your towing system.
See the vehicle owner's manual to determine the vehicle tow rating.
WARNINGS
Never exceed the vehicle manufacturer's recommended towing capacity. The ratings of the
channel-mount system are intended to represent the capability of the product and in no way
reflect the ratings or capacity of the towing system it is being used with. The consumer or
operator are strongly advised to learn the ratings of the various components of the towing
system and never exceed the limits of the lowest rated component being used.
Use of any pin other than that of the channel-mount system manufacturer
could be a serious safety hazard and will void the warranty.
Never hook up trailer safety chains to the channel-mount system. Ensure the safety chains
operate freely around the channel-mount system and do not become entangled.
Product Photo
Step 1
Insert the adjustable channel-mount into the
trailer hitch of the vehicle and secure with
the provided hitch pin & clip. Always secure
the hitch pin with a clip unless a locking
device is being used.
Step 3
Insert the pintle head into the channel
mount and raise or lower it to the desired
height. Insert the supplied pins through
the holes that line up with the holes in
the channel-mount and secure with the
provided clips.
Note: The supplied pins are specifically
engineered for the channel-mount system.
If replacement pins are needed, they must
be replaced with original factory channel-
mount pins (CURT# 45925).
Step 2
Insert the rubber anti-rattle bumper tightly
into the channel-mount to eliminate noise.
Note: Use of the rubber bumper is not
needed for safety; only to eliminate possible
rattle between the channel-mount and pintle.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
MacDon MT8 User manual
-
MQ Multiquip MP150SDLTS User manual
-
MQ Multiquip Trailers Operating instructions
-
MQ Multiquip Trailers Operating instructions
-
MULTIQUIP dca20spxu2 User manual
-
MQ Multiquip C30HDGA Operating instructions
-
MQ Power DCA20SPXU4F Operating instructions
-
MQ Multiquip DIS185SSI4F Operating instructions
-
Holder 4.74 User manual
-
MQ Multiquip AP6-AP8 Operating instructions
