Renkforce RF-2826052 Owner's manual

C4L6400-DIN Installation Manual

Model No. : C4L6400-DIN

The DIN rail mounting kit (Model number : C4L6400-DIN) is an accessory you can use to mount

C4L6400 series products to a standard DIN rail.

Devices such as C4L6400-EoC-P, C4L6400-TWP-P, C4L6400-2W-P, C4L6400-EoC, C4L6400-TWP,

C4L6400-2W, C4L6400-EoC-U, C4L6400-TWP-U and C4L6400-2W-U could be fixed with M4 Truss

Head Screw and M4 Nylon nut.

Installing on Devices with Screw and Nut

Complete the following steps to install the DIN rail mounting kit on the device.

1. Fasten the DIN rail mounting kit to the C4L6400 series product using a #1 Phillip screwdriver, M4

Truss Head Screw and M4 Nylon nut.

Note : Using the M4 Truss Head Screw and M4 Nylon nut permanently affixes the DIN rail mounting

kit and C4L6400 series product. Unscrewing and reinstalling the M4 Truss Head Screw and

M4 Nylon nut will produce a compromised connection between the DIN rail mounting kit and

C4L6400 series product.

2. Clip the device onto the DIN rail as shown in Figure 1 and 2.

Figure 1. DIN Rail Clip Parts Locator Diagram

Figure 2. Device Mounted on a DIN Rail