Extron DVI 110 User manual

Brand: Extron

Model: DVI 110

Type: User manual

The Extron

®

DVI 110 Signal Regenerator maximizes the

quality of a digital signal. The DVI 110 should be installed

at the beginning of a cable run, near the DVI source. The

cable from the source to the DVI 110 should be no longer

than 15 feet (4.5 m). To install the regenerator:

1. Mount the DVI 110 (optional).

2. Connect a DVI input device to the input connector on the DVI 110 rear panel.

NOTE::

Alternatively, the DVI 110 can be placed in the middle of a signal path to

improve a poor quality signal.

3. Connect a display device to the output connector on the DVI 110 front panel.

4. (Optional) To maximize signal quality, connect an Extron DVI 101 Cable Equalizer to

the output cable, immediately preceding the display device in the cable run. The

cable between the DVI 101 and the display should be no more than 15 feet (4.5 m).

NOTE: For best results when you are using a DVI 101, the total cable length

from the DVI 110 to the display should be 200 feet (61 m) or less.

5. Connect the provided 12 V, LPS, Class 2, 1 A external power supply

to the 2-pole captive screw connector on the DVI 110 rear panel.

DVI 110 Installation Guide

Extron Electronics, Anaheim, CA

www.extron.com

DVI 110 Installation Guide, cont’d

Application Diagram Example

DVI-D OUTPUT

POWER

12V

0.4A MAX

DVI 101

DVI-D OUTPUT

Projector

Extron

DVI 101

DVI Equalizer

Extron

DVI 110

DVI Regenerator

Extron

DVID SL Pro Series

200' (61 m) max.

Laptop with

DVI Output

Short DVI Patch Cable

15' (4.5 m) max.

Short DVI Patch Cable

15' (4.5 m) max.

Status LED

The Status LED on the front

panel lights to indicate the

following:

Amber – Unit receiving power

Green – Input signal present

DVI-D OUTPUT

POWER

12V

0.4A MAX

68-1974-50

Rev A

11 10

1

Extron DVI 110 User manual

Brand: Extron

Model: DVI 110

Type: User manual

Related papers

Other documents