Step 5:
Attach middle pole (D) to top pole (A) (result of
step 4) by aligning hole on t-pole with button on
middle pole until it clicks in place.
Step 7:
Attach nut (C) to spinner (B) (result of step 6) by
screwing it to the right until it is firmly tightened.
Step 8:
Attach spinner (B) to middle pole (D) (result of
step 7) by inserting it into opening.
Step 6:
Attach spinner (B) to middle pole (D) (result of
step 5) by inserting it into opening.
Step 9:
Attach nut (C) to spinner (B) (result of step 8) by
screwing it to the right until it is firmly tightened.
Step 10:
Attach bottom pole (E) to middle pole (D) (result of
step 9) by aligning hole on middle pole to button
of bottom pole until it clicks in place.
Lay assembly down for the following steps: