Backyard Chicken Coops Auto Door Opener Assembly Instructions

  • Hello! I am an AI chatbot trained to assist you with the Backyard Chicken Coops Auto Door Opener Assembly Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
ASeMlY INtUcToN
The Auto Door Opener
?
w
;
n
r
p
?
;
n
r
— How
Egg-citing!
Diagram
Diagram
Instructions
Twist the clock face
anticlockwise, then lift to remove
the face from the body.
StEp 2
Instructions
Use an electric drill to
attach the clock to the coop
directly above the door,
using two 15-20mm screws.
Also illustrated in step 4.
StEp 1
Diagram
Diagram
Instructions
Slide the coop door up, slide
bolt across to lock it into
place to keep it open.
StEp 4
Instructions
Gently life out battery compartments
and insert 2 batteries into each. Be
sure to insert the batteries the right
way up. Press down firmly to place
the two battery compartments back
into the original position.
StEp 3
This will
make our
lives easy!
1/4 of
the way!
Need some help? Contact the Backyard Chicken Coops team for advice on 1300 763 133 or [email protected]
2
Diagram
Diagram
Instructions
With a pen, make a mark on the
string directly below the clock as
indicated by the arrow.
StEp 6
Instructions
Place slight pressure with your
nger on the string loop hanging
below the clock and press the [DEC]
button. - this will release the string.
Release enough string so that your
nger is 3cm below the door handle.
StEp 5
Diagram
Diagram
Instructions
Now unlatch the door, attach
the string loop to the door
handle and press the [ADD]
button and this will raise the
door to it’s open position.
StEp 8
Instructions
Again, place slight pressure with your
nger on the string loop and press
[DEC] and release approximately
another 20cm of string. Now make
three knots on top of each other.
StEp 7
3cm
Pen mark,
make knot
here
20cm
WARNING: If the knot is
too small, the device may
snap the string which
will require the unit to be
returned for repair at a cost
of $35 + postage.
The knots are used to stop
the motor at that point.
Without the knots, the
motor will keep pulling and
cause internal problems.
I Can’t Wait
To Try It Out!
1/2 of
the way!
3/4 of
the way!
Need some help? Contact the Backyard Chicken Coops team for advice on 1300 763 133 or [email protected]
3
Instructions Instructions
> Hold down the [SET] Button until top
number fl ashes.
> Press the [ADD] button to increase hours
and [DEC] button to decrease hours.
> Press [SET] to adjust minutes once the
hour is correct.
> Press the [ADD] button to increase
minutes and [DEC] button to
decrease minutes.
> Press [SET] once again when the time
is correct.
> Using the same method to determine
the OPEN time, now set the time in the
middle section for current time and
also for CLOSE time.
> Once all the times are set, hold the
[SET] button until numbers stop
ashing to fi nalise adjustments.
Ensure the battery wires and
neatly inside the enclosure.
Replace clock face by aligning
the locking notches and twist
clockwise. It may seem stiff ,
but it is so to ensure 100%
waterproofi ng.
StEp 9 StEp 10
Setting the Clock
Final
Step
Woohoo! You’ve Assembled your Auto Door!
Time For a Drink
It’s easier
than it looks!
You Get My
Cluck of
Approval!
Need some help? Contact the Backyard Chicken Coops team for advice on 1300 763 133 or [email protected]
4
/