1. Using the chart above select Amplifier Output Capability; Example - 100W @ 8 = Terminal #3
2. The Negative of the Amplifier goes to #1 Terminal.
3. Find the Speaker Impedance Load from the appropriate chart below. Once again find the
amplifier power range (100W), then find the speaker impedance within that chart;
Example: Using Ohms law (10)70V Step Xfrmrs tapped @ 10W = (10/500 ) = 0.02 = (1/0.02) = 50
Therefore (+) of Speaker Lead goes to #6 Terminal.
4. The Negative of the Speaker also goes to #1 Terminal.
INSTALLATION MANUAL
THE BEAST
AMPLIFIER
CONNECTION
7
6
5
4
3
2
1
TERMINAL
AMPLIFIER OUTPUT POWER
300-400W
V(RMS)
VOLTS
IMPEDANCE IMPEDANCE
UP TO 175W
SPEAKER (+)
CONNECTION
7
6
5
4
3
2
1
100V
70V
56V
40V
28V
20V
0V
25
12
8
4
2
---
GND/COM
TERMINAL
AMPLIFIER 300-400W
SPEAKER
V(RMS)
VOLTS
IMPEDANCE
40W
30W
25W
20W
15W
10W
5W
3.8W
2.5W
1.5W
1W
0.5W
Constant Voltage Transformer
70V-Ohms on Step Down Tap 25V-Ohms on Step Down Tap
125
166
200
250
330
500
1000
1300
2000
3230
5000
10000
15
21
25
31
41
62
125
162
250
404
625
1250
SPEAKER (+)
CONNECTION
7
6
5
4
3
2
1
100V
70V
56V
40V
28V
20V
0V
TERMINAL
AMPLIFIER 175-225W
SPEAKER
V(RMS)
VOLTS
IMPEDANCE
50
25
16
8
4
2
GND/COM
SPEAKER (+)
CONNECTION
7
6
5
4
3
2
1
100V
70V
56V
40V
28V
20V
0V
TERMINAL
AMPLIFIER UP TO 175W
SPEAKER
V(RMS)
VOLTS
IMPEDANCE
100
50
---
16
8
4
GND/COM
100
50
---
16
8
4
GND/COM
50
25
16
8
4
2
GND/COM
IMPEDANCE
175-225W
25
12
8
4
2
---
GND/COM
100V
70V
56V
40V
28V
20V
0V
COMMON IMPEDANCES ON STEP DOWN TRANSFORMER TAPS
3
4
5
6
7
2
1
TERMINALS
SELECTING THE INPUT/OUTPUT CONNECTIONS
Exercise EXTREME CAUTION when using this device. Dangerously high voltages can be produced if improperly
installed causing equipment damage or personal injury. If you are unsure with any of the installation procedures
PLEASE CALL TECHNICAL SUPPORT BEFORE PROCEEDING.
MULTI-SYSTEM 400 WATT STEP UP TRANSFORMER
1-800-257-2077
Technical support can be reached Monday through Friday 9am-5pm EST