LevelOne WNC-0601 User manual

Category
Networking
Type
User manual

This manual is also suitable for

WUA-0606
150Mbps Wireless USB Adapter
User Manual
V2.0
Table of Contents
Chapter 1 Product Introduction...............................................................1
1.1
P
ACKAGE
C
ONTENTS
..........................................................................1
1.2
LED
I
NDICATOR
D
ESCRIPTION
..............................................................1
1.3
P
RODUCT
F
EATURES
..........................................................................2
1.4
P
RODUCT
U
SAGE
..............................................................................2
1.5
B
EFORE
I
NSTALLATION
.......................................................................3
1.6
D
ISABLE OTHER MANUFACTURERS
WIRELESS NETWORK ADAPTERS
...............3
1.7
P
RODUCT
M
AINTENANCE
...................................................................4
Chapter 2 Installation Guide ...................................................................5
2.1
H
ARDWARE
I
NSTALLATION
..................................................................5
2.1.1 Install the USB network adapter ............................................. 5
Chapter 3 How to use the Windows Built-in Wireless Configuration ........9
3.1
W
IRELESS
N
ETWORK
C
ONNECTION UNDER
W
INDOWS
XP ..........................9
3.2
W
IRELESS
N
ETWORK
C
ONNECTION UNDER
VISTA .................................. 13
3.3
W
IRELESS
N
ETWORK
C
ONNECTION UNDER
W
INDOWS
7 .......................... 16
Chapter 4 Client Wireless Utility ........................................................... 18
4.1
S
TATION MODE
(C
LIENT
M
ODE
) ......................................................... 18
4.1.1 Site Survey ............................................................ 19
4.1.2 Link Information .................................................... 22
4.1.3 Profile .................................................................... 24
4.1.4 Advanced ............................................................... 33
4.1.5 About..................................................................... 34
4.2
AP
MODE
..................................................................................... 34
4.2.1 Config AP ............................................................................. 37
4.2.2 Advanced ............................................................................. 38
4.2.3 Access Control List ............................................................... 39
4.2.4 Associate List ....................................................................... 40
4.2.5 AP Mode under Windows 7 ................................................ 41
Appendix 1: Acronyms and Terms ......................................................... 42
Appendix 2: How to Set WPS ................................................................ 43
Appendix 3: FAQ ................................................................................... 51
Appendix 4: Safety................................................................................ 54
-1-
Chapter 1 Product Introduction
Thank you for choosing this LevelOne wireless adapter!
The LevelOne WUA-0606 is a 11N wireless USB network adapter with up to
150Mbps wireless transmission rate. It complies with the latest IEEE802.11n
standard, and is compatible with 802.11b/g wireless devices. With mini and
exquisite design, it is easy to carry along. It supports WPS encryption method
to quickly implement wireless encryption and secure network; supports
WMM to better smooth video and sound; supports Windows 7, Vista,
Windows XP, Windows 2000.
In conclusion, WUA-0606 is a high-performance and cost-effective 11N
wireless USB network adapter with good signal, long transmission range etc.
1.1 Package Contents
WUA-0606 USB Adapter
Quick Installation Guide
CD Manual/Driver/Utility
The above list is for your reference only,the actual contents may differ
according to the product you purchase.
1.2 LED Indicator Description
There is one status LED indicator on the side of the wireless network adapter.
It lights up and stays ON when working correctly, and flashes when
transferring data.
-2-
1.3 Product Features
Supports 150Mbps receiving and sending rate
Complies with IEEE 802.11n and is compatible with IEEE 802.11b/g
standards
Supports 20MHz/40MHz frequency width
Detects wireless network and adjusts transmitting rate automatically
Provides two working modes: Infrastructure and Ad-Hoc
Supports WEP data encryption and WPA-PSK/WPA2-PSK encryption
methods
Supports WPS (Wi-Fi Protected Setup) encryption to secure your
wireless network
Complies with Windows 2000/XP/Vista/7.
1.4 Product Usage
The WUA-0606 Wireless USB Adapter offers a fast, reliable and extendable
solution for wireless access.
It is mostly used in the following circumstances:
1. Enables staff members who require greater mobility in the office to have
access to wireless networks anywhere inside their company.
2. Enables wireless communication for companies or places which are not
suitable for wired LAN installation because of budget or building environment
restrictions, such as historical buildings, rentals, or places for short-term
usage.
3. Suits businesses or individual who often changes network topology.
4. Suits company or individual who would like to avoid using expensive
cables or renting lines etc.
-3-
1.5 Before Installation
1. Please peruse this user guide before you install and use the product.
2. Please close or uninstall the configuration programs of other
manufacturers’ before you install the configuration programs of WUA-0606
Mato avoid possible UI collision.
3.In order to avoid possible network collision between this LevelOne network
adapter and those of other manufactures, we recommend you to first
disable the network of other manufacturer when installaing drive.
1.6 Disable other manufacturers’ wireless network adapters
1. Right click “My Computer” and select “Manage”
-4-
2. On the Computer Management screen ,select“Device Manager
“Network adapters”, and right click the network adapter you want to disable
and click “Disable”
3. Click the “Yes” button on the dialogue box to disable the network adapter.
1.7 Product Maintenance
1. Please keep the product away from water and humid environment to
guarantee its normal performance
2. Protect it against hazardous substances (such as acids, alkalis etc).
3. Please don’t directly expose the adapter to the sunlight or excessive
heat.
4. Please contact LevelOne tech support if any problems occur.
-5-
Chapter 2 Installation Guide
This chapter will guide you through the process of installing the network
adapter software package, with the included software CD. The package
integrates driver and configuration software. Thus, when you are installing
the driver, the configuration software will be installed automatically as well.
The software installation steps and operating guide in this user guide are
explained under Windows XP, Installation steps for other operating systems
are similar.
2.1 Hardware Installation
2.1.1 Install the USB network adapter
Please insert the Wireless USB Adapter into the USB port of your computer.
-6-
2.2. When The “Found New Hardware Wizard” system dialogue pops up,
we recommend that you select Cancel” and use the included Setup Wizard
software CD for fast installation.
2.3 Insert the included CD into the CD drive of your computer to auto-run the
program. (If it doesn’t auto-run, please double click Setup.exein the CD,).
When the below screen appears click “Utility”button.
-7-
2.4 Select “I accept the terms of the license agreement” and click “Next.
2.5 Two set up types are provided: one is “Install driver and LevelOne WLAN
Config Tool” ,the other is “Install driver only. We recommend you to use the
default installation method. click “Next
-8-
2.6. Click “Install” to install the driver and configuration software.
2.7 Click “Finish” to complete the installation.
-9-
Chapter 3 How to use the Windows Built-in
Wireless Configuration
This chapter explains to users who don’t install LevelOne configuration
program how to use Windows Built-in Wireless Configuration to connect to
the wireless network .
Use of the Windows Built-in Wireless Configuration requires enabling
Windows Wireless Configuration service(the default is enabled).
3.1 Wireless Network Connection under Windows XP
1. Right click “My Network Places” on the desktop and select “Properties”.
-10-
2. Open the network connection.Right click “Wireless Network Connection”
and select “View Available Wireless Networks” as shown below.
3. On the right of the screen displayed are the currently scanned wireless
networks. If the one you want to connect has not been scanned, click
“Refresh Network List” to update the network list.
Select the wireless network you want to connect, and click “Connect or
double click this wireless network. Input the key in the key dialogue box (the
key input is case-sensitive) then click “Connect.
NOTE: If the wireless device you are connecting to is not encrypted, the key
dialogue box will not pop up.
-11-
4.When it shows “Connected” as the picture below, then you can enjoy
wireless access to Internet now.
5. You can modify wireless network key from “Change advanced settings”.
-12-
6. Select “Wireless Networks”and choose the one you want to modify, and
then click “Properties”.
7. Modify the key in the appearing dialogue box.
-13-
3.2 Wireless Network Connection under VISTA
1. Click the Wireless Connection icon in the lower right corner of your
desktop and select “Connect to a network” as shown below.
2 Select the wireless network you wish to connect and click “Connect or
double click the wireless network to connect. Click the Refresh icon in the
upper right corner to update the network list if you don’t find the specified
wireless network.
-14-
3. If the wireless network that you are connecting has enabled security mode,
you’ll be prompted to enter the network key .Click “Connectafter you enter
the correct key.
1. The following screen will appear after successfully connected to the
wireless network.
-15-
2. If you want to change the wireless network key, just right click the
wireless network’s SSID and then select “Properties”.
3. You can modify the key from the appearing dialogue box.
-16-
3.3 Wireless Network Connection under Windows 7
1. Click the wireless connection in the lower right corner of the computers
desktop to view the available wireless networks. Select the wireless
network you wish to connect and click “Connect or double click the
wireless network to connect. If you don’t find the specified one, please
click the refresh icon in the upper right corner to update the list.
2. If the wireless network you are connecting is encrypted, you’ll be
prompted to enter the key. Click “Ok” after you enter the correct key.
-17-
3. It shows “Connected” after successfully connected. You can disconnect it,
view its status or modify the wireless network properties by right click the
wireless network
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54
  • Page 55 55
  • Page 56 56
  • Page 57 57
  • Page 58 58

LevelOne WNC-0601 User manual

Category
Networking
Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI