2. Mitsubishi
  3. M315088U25
M315088U25

Mitsubishi M315088U25 User manual

  • Hello! I've reviewed the Owner's Manual for the Capacitive Touch Pad. This document details the touch pad's operation, including locking, unlocking, override procedures, and compatibility with various conditions like gloves, rain, and extreme temperatures. I'm ready to assist with any questions you have about its use or features.
  • What is the initial power up delay?
    What indicates that the touch pad has been disabled?
    What indicates that the touch pad has been enabled?
*CTP-OM-01* CTP-OM-01
© Lumen Australia 2019
CTP-ASM-XXX
DRAFT
TO BE FINALISED
Checkers Initials
Date Checked
Capacitive Touch Pad
Owner's Manual
Issue: 1 Date: 19/06/2019
X
General Operation
Weather
Cover
Lock Barrel
External Override
Outer Zone Activation Outer Zone
Zone
Initial Power up delay: 10 seconds
+ -
10Sec
Preferred Activation Method:
02
✔ ✔
X
General Operation
Touch Pad Active / Inactive Table
Rear Window Status Vehicle Lock Status Touch Pad Status
✔
X
X
X
03
Thank You
Thank you for purchasing a Lumen Capacitive Touch Pad.
Please read through this manual for operating instructions before using your Lumen
Touch Pad.Capacitive
Introduction
The Capacitive Touch Pad is a standalone electronic device located at the rear entry point
of the canopy.
The Capacitive Touch Pad is used to control and simplify entry to the rear of the canopy.
Disclaimer
The Lumen Touch Pad must not be altered in any way.
During change of environmental conditions such as rain, the Lumen Capactive Touch Pad
will re-calibrate it's touch sensitivity and may not operate for 2 seconds during this time.
Capacitive
Fuse
Panel
T-Patch
Ring Terminal
T-Patch
Capacitive
Touch Pad
Wiring Diagram
Dome
Light
Door
Switch
General Operation
Canopy Unlatch via Activation Zone:
The Capacitive Touch Pad monitors the base program vehicle lock /unlock status. If the
base program vehicle is unlocked & the rear canopy door closed the touch pad will
become “Active”.
If the Activation Zone is pressed while the Touch Pad is active for approximately 1 second
using your thumb or two index fingers the Capacitive Touch Pad will cycle the rear canopy
door actuator to release the door latches, allowing access.
Activation Zone
Rear Window Status Vehicle Lock Status
Closed
Closed
Ajar
Ajar
Unlocked
Locked
Unlocked
Locked
Touch Pad Status
Active
Inactive
Inactive
Inactive
Touch Pad Active / Inactive Table
General Operation
Quick Guide
The Touch Pad will ignore any button press where any part of the finger or thumb is also
touching outside the activation zone.
We recommend using your thumb or two fingers to press the as the
will ignore any button press < than 14mm in diameter
The constantly re-calibrates & adjusts its capacitive sensitivity to suit changing
environmental conditions (Rain, Ice, Dust & Dirt) during this recalibration the
may become inactive.
If the user repeatedly presses or holds the within a short period of time, the
will consider the presses as being part of the environmental conditions and re-
calibrate to de-sensitize the . If this happens remove your hand from the
for 2-5 and the will return to its original calibration.
On initial installation and/or power up the requires 10 seconds to perform
recalibration.
Touch Pad Touch Pad
Touch Pad
10 seconds
Touch Pad
Touch Pad
Touch Pad
Touch Pad Touch
Pad seconds Touch Pad
Touch Pad
Press to unlock vehicle & canopy
Press & release to unlock canopy
Rear hatch opens
General Operation
Quick Guide: Unlock & Open
Unlock
Button
1 2
x1
Activation
Zone
3 4
1Sec
>14mm
04
General Operation
Quick Guide: Close & Lock
2
1
3
Lock
Button
x1
05
1 1
1
1
11
1
1
11
11
P
P
A
AA
A
Nissan pointers
P
P
Common Fasteners
Pointers
External Manual Release:
If required, the canopy rear door can be unlocked and unlatched via the key manual barrel.
Lift the flap on the Lumen Capacitive Touch Pad, insert the key and rotate until canopy
door/window is unlatched. Note: Manual operation is normally only used in the even
of no power or complete system failure, however this feature can be used whenever
is r uired.
Internal Manual Release:
If required the rear canopy door can be unlatched from inside the canopy.
To unlatch the canopy, remove the rubber cap (1) and locate the metal lever (2) with dipped
red end and push or pull it across until latches release.
eq
General Operation
External Manual Release:
1 2
Internal Manual Release:
VIEW FROM INSIDE CANOPY
1
2
1
2
06
1 1
1
1
11
1
1
11
11
P
P
A
AA
A
Nissan pointers
P
P
Common Fasteners
Pointers
4
1Sec
General Operation
Capacitive Touch Pad Override: Disable
Unlock
Button
1 2
x1
1Sec
3
6
x4
Four actuator cycles
indicates that the
Touch Pad has been
disabled
1Sec
5
1Sec
>14mm
4
07
✔
X
7
05
Activation
Zone
Outer Zone
Outer Zone
Operating the System
The system is on when the key or switch is turned to 'ON' or 'IGNITION', and the park
brake is released.
When the Genuine Hyundai Front Park Assist System is turned on, the system
generates a single beep for one second and then a re-occuring beep every 2.5
seconds to indicate to the driver that the system is operational.
- When the Front Park Assist System is 'ON', pressing the Park Assist switch will turn
the Front Park Assist System 'OFF'.
- Pressing the Park Assist switch again will turn the Front Park Assist System 'ON'.
- Driving above 10km/h will turn 'OFF' the Front Park Assist System.
- To turn 'ON' for parking, press the Park Assist switch again.
- Selecting the reverse gear will turn the Front Park Assist System 'ON'.
Touch Zone
Step 5. Touch the middle Activation zone.
Process is now complete, if
successful you will hear the actuator
inside the rear door cycle.
Note: Repeat the entire process to re-enable the touch pad.
Four actuator cycles indicates that the Touch Pad has been disabled. Image of cross.
Two actuator cycles indicates that the has been enabled image of tick.
Ensure your touch is inside the border of the designated zone when pressing it. If your
fingers crosses over zone borders you will need to start sequence again.
Vehicle / Canopy must be unlocked and ajar before this function can be used. Whilst the
is disabled you will only be able to unlock and unlatch the canopy using the
“External Manual Release”.
Touch Pad
Touch Pad
General Operation
Capacitive Touch Pad Override: Enable
1
Unlock
Button
2
x1
3
1Sec
4
1Sec
6
1Sec
>14mm
5
08
7
x2
Two actuator cycles
indicates that the
Touch Pad has been
enabled
✔
8
✔
Compatibility:
Gloves: The Capacitive Touch Pad has been successful tested to detect touches on the
activation zone when the user is wearing commonly used gloves of varying materials,
however performance with all gloves cannot be guaranteed. If the does not
seem to respond whilst wearing certain gloves please remove them before next use.
Ice & Snow: The has been successfully tested to detected touches
on the activation zone when under a light cover of ice. However thick ice build up or snow
may reduce the sensitivity. If this reduced sensitivity is affecting performance the user
should remove the ice or snow build up before next use.
Rain & Wet: The has been successfully to be tested to detect
touches on the activation zone in light rain conditions. However heavy rain may reduce the
sensitivity of the or activate the environmental control feature . If this reduced
sensitivity is affecting performance the user should shelter the during use.
Dirt: The has been successfully tested to work with a light cover of
dirt & dust. However thick dirt or mud may reduce the sensitivity. If this reduced sensitivity
is affecting performance the user should remove the mud or dirt before next use.
Cold & Heat: The has been successfully tested to operate in
extreme temperatures conditions -40°C to +105°C.
Immunity: The has been configured to ignore un-intended triggers
when exposed to the following conditions: Carwash, Direct Hose, Dripping Water, Wind,
Dust etc. however the immunity of the cannot be guaranteed in all user cases.
If the user wants to ensure the remains inactive in all conditions then
the user may lock the base program vehicle &/or deactivate the Capacitive by
following the “disable function” instruction in this booklet.
Touch Pad
Capacitive Touch Pad
Capacitive Touch Pad
Touch Pad
Touch Pad
Capacitive Touch Pad
Capacitive Touch Pad
Capacitive Touch Pad
Touch Pad
Capacitive Touch Pad
Touch Pad
General Operation
Compatibility:
Border Control:
>14mm
X
✔
X
Gloves
>14mm >14mm
✔ ✔
X
09
X
✔
Ice & Snow:
0
X
>14mm
✔
General Operation
Compatibility:
Ice & Snow:
>14mm
X
✔
0
✔
Rain & Wet:
X
>14mm
✔✔
10
X
✔
General Operation
Compatibility:
Dirt:
>14mm
X
✔✔
X
105c°
-40c°
-50c°
X
110c°
>14mm
✔
Immunity: The has been configured to ignore un-intended triggers Capacitive Touch Pad
Cold & Heat:
when exposed to the following conditions: Carwash, Direct Hose, Dripping Water, Wind,
Dust, etc. however the immunity of the Touch Pad cannot be guaranteed in all user cases.
If the user wants to ensure the Capacitive Touch Pad remains inactive in all conditions then
the user may lock the base program vehicle &/or deactivate the Capacitive Touch Pad by
following the “disable function” instruction in this booklet.
11
© COPYRIGHT 2019
E. & O.E. This document is copyright and must not be used except as permitted below or under the Copyright Act
1968. You may reproduce and publish this document in whole or in part for you or your organisation's own Personal
or internal compliance, educational or non-commercial purposes. You must not alter or amend this document in any
way. You must not reproduce or publish this document for commercial gain without the prior written consent of the
copyright owner.
/