2. DV8 OFFROAD
  3. D-JP-181101-BL

DV8 OFFROAD D-JP-181101-BL Installation guide

  • Hello! I've reviewed the installation instructions for the Drake Off Road JK Billet Pistol Grip Shifter Handle. This document outlines the process of replacing your vehicle's stock shifter with the new pistol grip style handle, using tools like hex wrenches and a trim stick. I'm ready to answer any questions you have about the installation process or the product itself.
  • What tools are needed for installation?
    How do I remove the stock handle?
    How do i attach Pistol Grip?
2011 Jeep JK Billet Pistol Grip Shifter Handle
INSTALLATION INSTRUCTIONS
Tools needed for installation:
• 3mm hex wrench
• 4mm hex wrench
• Small slot screwdriver or trim stick
Installation:
Remove stock handle:
Carefully using a screwdriver or trim stick, separate the
retaining ring from the knob and slide down the shifter shaft.
Pull the knob off the shifter shaft.
•
•
Jeep Pistol Grip:
130 Cassia Way • Henderson, NV 89014 • 702.853.2060 • 702.853.2062 Fax
www.DrakeOffRoad.com
Enjoy your new shifter from Drake Off Road!
Remove button head cap screws from Pistol Grip sides.
Loosen set screws until base fits over shifter shaft.
Tighten set screws incrementally until both are against flats on shifter shaft.
Now tighten set screws firmly.
Reinstall button head cap screws.
•
•
•
•
•
SET SCREWS (2)
BUTTONHEAD SCREWS (4)
Trim stick Knob
Retaining
Ring
Knob
Retaining
Ring
REMOVING STOCK HANDLE
PISTOL GRIP ASSEMBLY
/