(888) 782-5618
• Twist the Plastic Frame (Part B) and remove it from the Solar Panel
Unit (Part A).
• Twist the plastic lens from Solar Panel Unit (A)
• Pull out the tag which is on the bottom of the Solar Panel Unit (Part A )
• Replace the Plastic lens accordingly.
Figure 1:
• Insert the Tube (Part C) to Plastic Frame (Part B), and then the Path
Light Spike (Part D) .
• Take the light to the area where it can receive a full 8 hours of
sunlight to allow the rechargeable battery to reach maximum capacity.
Note: Lights with solar panels may have a protective film over the solar
panel. This must be removed prior to use.
1. Use a damp cloth to clean the solar panel
2. To avoid any damage to this light, please do not use any chemical or abrasive cleaner
HOW TO OPERATE AND INSTALL
HOW IT WORKS
CLEANING AND MAINTENANCE
8PK Solar Light (6PC pathlight + 2PC spotlight)
Model No. ELI0982V
Each path light contains (1)1.2V AA 300mAh Ni-MH rechargeable battery; Each spot light
contains (1)1.2V AA 600mAh Ni-MH rechargeable battery. When the battery expires, it must be
recycled or disposed of properly. Please contact your local waste disposal authority for correct
procedure. Do not put battery into fire.
Battery replacement
For Path Light (See Figure 5)
• Twist the Plastic Frame (Part B), plastic lens and remove them from the Solar Panel Unit (Part A).
• Open the battery chamber cover on the bottom of solar panel unit (Part A).
• Replace the old battery with a new battery making sure the polarity is correct.
• Reposition the battery cover tightly
For Spot Light (See Figure 6)
• Open the battery chamber cover on the bottom of the Solar Panel Unit (Part E) as figure 6
• Replace the old battery with a new battery making sure the polarity is correct.
• Reposition the battery cover tightly
RECHARGEABLE BATTERY
securit y
www.homezonesecurity.com
Solar panel collects sunlight to
charge the battery (included) during
the day
1Automatically turns on at dusk for up
to 8 hours of nighttime illumination
2
For Path Light
Figure 3:
Figure 4:
• Slide the switch located on the bottom of the Solar Panel Unit (Part E) to
“ON” position
Figure 2:
• Insert the Spot Light Spike (Part G) to the Light Body (Part F)
• Take the light to the area where it can receive a full 8 hours of sunlight
to allow the rechargeable battery to reach maximum capacity.
Note: Lights with solar panels may have a protective film over the solar
panel. This must be removed prior to use.
For Spot Light
E
F
G
A
B
C
D
Figure 2
Figure 4
Figure 1
Figure 3