securit y
www.homezonesecurity.com
Model No. ES00730V
DO NOT connect electricity before installation and maintenance.
1. Screw the center bolt with washer to the bracket with screw thread
facing outward (preinstalled by factory) .
Fix the bracket installation hole with the junction box hole and use the
mounting screws to secure into place.
securit y
www.homezonesecurity.com
TEST
TIME
MOON SUN
DUSK
LUX
Model No. ES00730V
1. PHOTOSENSOR SENSITIVITY is adjustable by sliding the
"LUX" switch. The light fixture will light on at corresponding
ambient light intensity when activated.
MOON: lights on at night only
DUSK: lights on at dusk to dawn
SUN: lights on at the day and night
2. STAND-BY time is adjustable (30s / 60s / 120s) by sliding
the "TIME" switch.
3. ANGLE INTERPRETATION: motion sensor moves up and
down at angle 0-90 degrees, and left to right at 0-330 degrees.
4. Manually override the motion sensor for continous on at
night. The light will reset to motion sensor mode after 6
hours or sunrise.
- Ensure the power to the light is on and the sensor has
warmed up for 1minute.
- To turn manual override on, switch the power
OFF-ON-OFF-ON at the wall switch within 3 seconds.
- To turn manual override off, switch the power
OFF-ON-OFF-ON at the wall switch within 3 seconds.
U
Wiring the light and junction box through the spongy cushion:
a. Connect the white wire to the white by terminal blocks
b. Connect the black wire to the black by terminal blocks
c. Connect the green wire of light to the green wire from junction box using
ground screw (painting green) onto the bracket
Install the light on the spongy cushion and bracket by screwing the barrel nut
(with white washer) to the center bolt on the mounting bracket.
DO NOT cut or remove any connectors on the wire to make sure the
positive and negative connection is correct.
Please remove the protective paper barrier from the adhesive face of the
spongy cushion.
/
