Construction Metals 10112-1R Operating instructions

Type
Operating instructions

This manual is also suitable for

A Window Flashing can help avoid costly water damage by directing moisture away from the window from the
top down. Window Flashing, also known as Drip Cap is required by most building codes.
WINDOW FLASHING #FLGAWF
INSTALLATION GUIDELINES
1. Cut the Window Flashing to allow 1/2 inch overhang on each side of the window you are protecting. Position the Window
Flashing and apply flashing tape to the top edge
2. Secure the Window Flashing using 3 galvanized nails. The Window Flashing will form an awning over the window. Apply a dab
of caulking to the nail heads.
3. Building paper should overlap the flashing tape and the Window Flashing and then be covered by the siding.
4. Cut and bend the overhanging Window Flashing to make flaps on each end. The resulting flaps should be sealed with exterior
grade sealant to create wind-resistant sides.
Building Paper
Flashing Tape
Window Flashing
These basic installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed
professional, and to check with your local building inspector or building permit office for approvals and possible variations that may apply.
  • Page 1 1

Construction Metals 10112-1R Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI