Gibraltar Building Products WT22B Operating instructions

A Water table flashing can help avoid costly water damage by directing moisture away from the window from

the top down. Water Table flashing, also known as Drip Cap is required by most building codes.

WATER TABLE #WT22B/WT22G

INSTALLATION GUIDELINES

1. Cut the Water Table flashing to allow 1/2 inch overhang on each side of the window you are protecting. Position the Water Table

flashing and apply flashing tape to the top edge

2. Secure the Water Table flashing using 3 galvanized nails. The Water Table flashing will form an awning over the window. Apply a

dab of caulking to the nail heads.

3. Building paper should overlap the flashing tape and the Water Table flashing and then be covered by the siding.

4. Cut and bend the overhanging Water Table to make flaps on each end. The resulting flaps should be sealed with exterior grade

sealant to create wind-resistant sides.

Building Paper

Flashing Tape

Water Table Flashing

These basic installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed

professional, and to check with your local building inspector or building permit office for approvals and possible variations that may apply.