120 Glasgow Avenue
Inglewood, California 90301
U.S.A.
Copyright 2010 DoorKing, Inc. All rights reserved.
6500-465-A-11-10
The ball joint assembly is used to connect a gate to the 6050, 6100, 6300 or 6500 operator arm when the operator has been
installed horizontally level and the gate opens on an uphill or downhill slope. The ball joint will stay at the same angle as the gate
bracket during gate cycling while the operator arm remains swinging horizontally level.
An un-level swinging gate MUST be restrained from opening or closing too quickly (gate runaway) when not connected to the
gate operator. DoorKing offers a torsion rod assembly (P/N 1203-084, extra torsion rod P/N 2600-299) for un-level swinging gates
that provides counter-balancing torsion rods to prevent gate runaway and relieving the pressure on the gate operator when the gate
is in the downhill position.
DoorKing Part Number
6500-490
BALL JOINT PIVOT ASSEMBLY
Conne
ct to existing
gate bracket.
Ball
Joint
Existing
Safety
Cover
Assy
Gate Picket
Gate Closed - Uphill Slope
Slope
Angle
Slope
Angle
Gate Closed - Downhill Slope
Gate Picket
Gate Picke
t
Gate Opened - Downhill Slope
Gate Opened - Uphill Slope
An un-level swinging gate MUST
be restrained from opening or
closing too quickly when not
connected to the gate operator.
Operator must be level.
Operator must be level.
Installation
Co
nnect to existi
ng DoorKing operator arm ONLY.
-
1
DKS 6500 Swing Gate Accessories Pivot Arm User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
DKS Torsion Rod User manual
-
-
-
DKS 6050 / 6100 Pad Mount Kit User manual
-
-
-
-
-
-
