Symmons SLW-4212 Installation guide

Symmons
Brand
Symmons
Model
SLW-4212
Category
Faucets
Type
Installation guide

This manual is also suitable for

Symmons SLW-4212-1.0 is a two-handle widespread lavatory faucet with a pop-up drain. It is made of brass and has a chrome finish. The faucet has a flow rate of 1.0 gpm and comes with a 2.2 gpm aerator. The faucet is easy to install and comes with all the necessary hardware. It is also easy to clean and maintain. The faucet is perfect for any bathroom and will provide years of trouble-free use.

Symmons SLW-4212-1.0 is a two-handle widespread lavatory faucet with a pop-up drain. It is made of brass and has a chrome finish. The faucet has a flow rate of 1.0 gpm and comes with a 2.2 gpm aerator. The faucet is easy to install and comes with all the necessary hardware. It is also easy to clean and maintain. The faucet is perfect for any bathroom and will provide years of trouble-free use.

Non-
Removable Removable
stopper stopper
Quick Install Guide Oxford Two Handle Widespread Lavatory Faucet, SLW-4212
Fasten drain body and
tail piece to sink
Step 5
Step 1
Attach faucet spout
Step 3
Attach faucet handles
Step 2
Install stopper and pivot
rod to drain body
Step 6
Connect lift rod, clevis strap,
pivot rod and adjust linkage
Step 7
Attach control valves to sink
Step 1
Flush water supply lines
Step 8
Step 1
Connect water supply lines
Step 4
HOT
COLD
Plumbers
Putty
Pipe
Sealant
3/32"
1 2 3 4
 Need Help?
Contact Symmons customer service at
(800) 796-6667, (781) 848-2250
Email: [email protected]
Monday - Friday 7:30 am - 7:00 pm EST
Please check Symmons website
for technical help, the latest product
information and warranty policy.
www.symmons.com/service
Tools & Materials
Installation and Service Instructions
Oxford
™
Two Handle Widespread Lavatory Faucet
Alternate Finish Code
append to part numbers when applicable
-STN
Satin Nickel
-ORB
Oil rubbed bronze
--
Chrome (standard)
Model Number
SLW-4212
Two Handle Lavatory
faucet with pop-up drain
SLW-4212
Caution: If replacing an older faucet ensure water supply is
turned OFF before removing. Then open faucet valves to relieve
water pressure.
Step 1 Attach control valves
Step 2 Attach handles
Step 3 Attach spout
3/32" Allen
wrench
OFF
OFF=CW
OFF=CCW
back of sink
front of sink
Step 4 Connect water supply lines
Step 5 Fasten drain body
1
2
PLUMBERS
PUTTY
ange
beveled
washer
friction
washer
ange nut
back
of sink
*
ange washer
(optional)
*
use included ange
washer only when
Plumbers putty is
not available or
when drain hole
dictates
tail
piece
teon
tape
HOT
COLD
Pipe
Sealant
screw down until
thread stops
Installation Instructions
Page 2
Step 6 Install stopper and pivot rod to drain
Step 7 Connect lift rod and adjust linkage
Care of faucet finish
Clean finish area by using mild soap and water or non-abrasive
cleaner and then rinse immediately. A non-abrasive wax may be
used to preserve finish area.
Valve cartridge replacement
Step 8 Flush water supply lines
3/32" Allen
wrench
3/32" Allen
wrench
OFF position
OFF = CW
OFF = CCW
Replace appropriate hot
and cold cartridge as
referenced in Replace-
ment Parts table.
May also use a 17mm
deep socket wrench.
1 2 3
Drain body
1/2" (13 mm)
Pipe
Sealant
1
2
non
removable
removable
Page 3
Part Number Item
Replacement Parts
handle
screw
collar
fastener
gasket
KN-113E
identified
by groove
KN-114E (hot)
OFF = CW
KN-113E (cold)
OFF = CCW
valve cartridge
LN-333-KIT
FLR-102-1.5-KIT
LN-742-KIT
WSF-422L-KIT
*
includes two handle
assemblies
removal key
included
aerator
aerator flow rates
2.2 gpm (8.3 L/min)
1.5 gpm (5.7 L/min)
1.0 gpm (3.8 L/min)
Parts Assembly Oxford Two Handle Widespread Lavatory Faucet, SLW-4212
Ordering replacement parts:
Call Symmons customer service at (800) 796-6667,
(781) 848-2250 M-F 7:30 am - 7:00 pm EST or
check our website at www.symmons.com for a
list of Symmons distributors.
standard aerator
2.2 gpm
faucet handle
reference table
valve cartridge
reference table
lift rod
LN-572*
stopper
P-100N*
pop-up drain
assembly
RL-154LR
*
includes stopper
spout
LN-610*
spout base
LN-571*
*
Note: When ordering replacement parts for
faucets with an optional decorative nish, append
appropriate three letter nish sufx code to part
numbers marked with an asterisk (
*
).
1/2"-14 NPSM
1" dia (25 mm)
Hole size
1-1/16" (27 mm) min
1-7/16" (37 mm) max
4" (102 mm) min
Flexible hose
2" (51 mm) square
8"(203mm) min
16"(406mm) max
Deck thickness
1-3/8" (35 mm) max
Note: Dimensions subject to change without notice.
2-3/4" (70 mm)
5-3/8"
(136 mm)
2-1/4" square
(56 mm)
5/8" dia. (16 mm)
Hole size
1-1/4" (32 mm) min
1-1/2" (38 mm) max
7-3/8"
(187 mm)
3-1/2"
(89 mm)
5-3/8"
(135 mm)
5-1/8" (130 mm)
3-1/4"
(83 mm)
1-1/8"
(28 mm)
5/8" (15 mm)
Dimensions Oxford Two Handle Widespread Lavatory Faucet, SLW-4212
Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02189
(800) 796-6667 ■ Fax (800) 961-9621 ■ Website:
www.symmons.com
Email:
[email protected]
© 2014 Symmons Industries, Inc. Printed in U.S.A. ■ ZV-587 ■ 073014
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Symmons SLW-4212 Installation guide

Symmons
Brand
Symmons
Model
SLW-4212
Category
Faucets
Type
Installation guide
This manual is also suitable for

Symmons SLW-4212-1.0 is a two-handle widespread lavatory faucet with a pop-up drain. It is made of brass and has a chrome finish. The faucet has a flow rate of 1.0 gpm and comes with a 2.2 gpm aerator. The faucet is easy to install and comes with all the necessary hardware. It is also easy to clean and maintain. The faucet is perfect for any bathroom and will provide years of trouble-free use.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents