Smart Access Controller K2/K2F
Model :
Dimensions :
Material :
Communication :
Supporting systems :
Stand-by current :
Operating current :
Power supply ：
Unlocking time：
Waterproof level ：
Card capacity：
K2/K2F
W79mm x H125mm x T15.5mm
Aluminum frame/Tempered glass panel
Bluetooth 4.1
Android 4.3/IOS7.0 above
≈5mA
≈1A
12V
≈1.5S
IP66
20,000 Cards
Accessories
Access
controller x1
Cable x1
Manual x1
Mounting plate x 1
Screw: 2+4+1
Hook x 1
Manual
Limited Warranty
Install the hook
4
Install the access controller
5
Fix the hook to the mounting
plate with 2 screws.
Fit the access controller into the hook and fix it on the mounting plate
with a screw in the bottom.
Manual
SMART
ACCESS CONTROLLER
Tap the panel to light
it up and activate the
lock.
On voice prompt “Please add
Bluetooth Administrator”,
activate the APP.
中国电信 16:59
APP
21
Tap the “三” icon on the upper
left corner, tap “+Add Lock”,
select “Door Lock”.
3Tap the device shown on the
screen. Wait a few seconds
till the lock gives a voice
prompt/long beap, which
means it is added successfully.
4
中国电信 16:59 中国电信 16:59
Nearby locks
AIDJDNV62SJ
AIDJFGV62SJ
AIDJDN324U
中国电信 16:59
Choose lock Type
door lock padlock
All locks
Scan all types of locks
Pair the access controller with app
Add lock
Message
Customer service
settings
Add lock
Notice: If fails, please shut off the APP and Bluetooth，turn them on and try the above process again.
!
For any defect in material and workmanship, the original
purchaser of the product
1)Can return or ask for a replacement within 7 invoice days.
2)Can ask for a replacement within 15 invoice days.
3)Can ask for free repair in 365 invoice days.
This warranty does not cover defects caused by modification,
alteration, misuse or physical abuse of the product.
1.
2.
Illustration
Magnetic strike
Power source
Controller
Exit button
Door bell
Access controller
Drill a hole for the cable
1Install the mounting plate
2
Drill a hole at appropriate
position to make space for the
cable to connect to the power
source.
Fix the mounting plate with 4
screws.
Wiring
3
Connect the cable of the access controller to power cable and other ports
according to the illustration.
DC12V IN
Access
controller
Magnetic strike
Power source
Exit button
Door bell
12V
CONTROL
CONTROL
UPS-
UPS+
PUSH
GND
12V
NC
GND
NO
+12V
GND
BELL
BELL
+12V
GND
NC
COM
NO
SW
IN
OUT
BELL
BELL
V+
V-
NO
COM
NC
DOOR
EXIT
1
CAMDEN CV-603 Reference guide
QOLSYS QS9207-5208-124 Installation guide
ZKTeco ZK_PA22 User guide
Soyal AR-837-EA Owner's manual
Soyal AR-837-EL Owner's manual
Soyal AR-837-EA-T Owner's manual
QOLSYS QS9201-1230-840 User manual
Videx DIGITAL VX2200 System Manual