Welch Allyn 58014 Mounting instructions

Brand: Welch Allyn

Model: 58014

Type: Mounting instructions

Vaginal Speculum

Storage Dispenser

Model # 58014

Mounting Instructions

Vaginal Speculum

Storage Dispenser

Model # 58014

Mounting Instructions

The storage dispenser comes with four rubber, non-skid feet mounted to the bottom surface. You can

place the storage dispenser on a countertop or, if desired, follow the directions below to mount it to

a wall.

Affixing the Storage Dispenser to wallboard:

Tools required: Phillips Screwdriver, Wall Anchors/Screws (provided), Pencil

1. Locate the desired wall location for the storage unit and verify there are no wall studs behind

the wallboard. Hold the dispenser on the wall and use the pencil to mark the hole location on

the wall for the bottom screw at the top of the bottom screw slot. Set the dispenser aside.

2. Drive a wall anchor into the marked hole location on the wall until it is fully seated. Then drive

a screw into the wall anchor until the screw head is approximately 1⁄8” (3mm) from the wall.

See Figure 2.

3. Fit the round key hole in the bottom the system over the screw head on the wall and push

down.

4. Level the storage dispenser and, using a pencil, mark the two top hole slots. Remove the

dispenser from the wall and secure a wall anchor completely into the wall at each marking.

5. Replace the storage dispenser on the bottom screw. Place a screw through the top, left

dispenser hole slot and secure it into the wall anchor. Do not overtighten! Repeat for the right

side.

6. Place one of the enclosed sizing stickers on the front of the dispenser and fill with appropriate

size specula.

1/8” / 3 mm

Figure 2

Storage Dispenser Top Hole Slots

Storage Dispenser Bottom Key Hole Slot

Figure 1

The storage dispenser comes with four rubber, non-skid feet mounted to the bottom surface. You can

place the storage dispenser on a countertop or, if desired, follow the directions below to mount it to

a wall.

Affixing the Storage Dispenser to wallboard:

Tools required: Phillips Screwdriver, Wall Anchors/Screws (provided), Pencil

1. Locate the desired wall location for the storage unit and verify there are no wall studs behind

the wallboard. Hold the dispenser on the wall and use the pencil to mark the hole location on

the wall for the bottom screw at the top of the bottom screw slot. Set the dispenser aside.

2. Drive a wall anchor into the marked hole location on the wall until it is fully seated. Then drive

a screw into the wall anchor until the screw head is approximately 1⁄8” (3mm) from the wall.

See Figure 2.

3. Fit the round key hole in the bottom the system over the screw head on the wall and push

down.

4. Level the storage dispenser and, using a pencil, mark the two top hole slots. Remove the

dispenser from the wall and secure a wall anchor completely into the wall at each marking.

5. Replace the storage dispenser on the bottom screw. Place a screw through the top, left

dispenser hole slot and secure it into the wall anchor. Do not overtighten! Repeat for the right

side.

6. Place one of the enclosed sizing stickers on the front of the dispenser and fill with appropriate

size specula.

1/8” / 3 mm

Figure 2

Storage Dispenser Top Hole Slots

Storage Dispenser Bottom Key Hole Slot

Figure 1

To clean the Vaginal Speculum Storage Dispenser, wipe it with 70% Alcohol, CaviWipes, or 10%

Bleach Solution.

Limited Warranty

Instrumentation purchased new from Welch Allyn, Inc. (Welch Allyn) is warranted to be free from

original defects in material and workmanship under normal use and service for a period of one year

for the Welch Allyn Vaginal Speculum Storage Dispenser (REF 58014) from the date of first shipment

from Welch Allyn. This warranty shall be fulfilled by Welch Allyn or its authorized representative

repairing or replacing at Welch Allyn’s discretion, any such defect, free of charge for parts and labor.

Welch Allyn must be notified via telephone of any defective product and the item must be

immediately returned, with an RMA number provided by Welch Allyn, securely packaged and

postage prepaid to Welch Allyn . Loss or damage in shipment shall be at the purchaser’s risk.

Welch Allyn will not be responsible for loss associated with the use of any Welch Allyn product that

(1) has had the date of manufacture number defaced, (2) has been repaired by anyone other than an

authorized Welch Allyn Service Representative, (3) has been altered, (4) has been used in a manner

other than in accordance with the instructions, or (5) has been abused or exposed to extreme

environmental conditions.

THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY IMPLIED WARRANTY OR MERCHANTABILITY,

FITNESS FOR PARTICULAR PURPOSE, OR OTHER WARRANTY OF QUALITY, WHETHER EXPRESSED

OR IMPLIED. WELCH ALLYN WILL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL

DAMAGES RESULTING FROM THE SALE, USE, OR IMPROPER FUNCTIONING OF THE

INSTRUMENTATION REGARDLESS OF THE CAUSE. THE DAMAGES FOR WHICH WELCH ALLYN

WILL BE RESPONSIBLE INCLUDE, BUT ARE NOT LIMITED TO, LOSS OF REVENUE OR PROFIT,

DOWNTIME COSTS, AND LOSS OF USE OF THE INSTRUMENTATION.

Manufactured for Welch Allyn

4341 State Street Road

Skaneateles Falls, NY 13153 USA

800-535-6663 • 315-685-4560 • 315-685-3361

Material No. 1200008

The CE mark on this product indicates that it has been tested to and conforms

with the provisions noted within the 93/42/EEC Medical Device Directive.

Authorized European Representative Address:

European Regulatory Manager

Welch Allyn, Ltd.

Navan Business Park

Dublin Road

Navan, County Meath,

Republic of Ireland

Tel: 353-46-67700

Fax: 353-46-27128